modway EEI-3416 User manual

EEI-3416 CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 1 of 2
Thank you for purchasing the MODWAY Chair.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6X30mm x4
Flat Washer x4
1. Chair Body x1 2. Chair Base x1 3. Seat Cushion x1
A.
C.
Allen Wrench M6 x1
D.
Spring Washer x4
B.
Allen Wrench M8 x1
E.

EEI-3416 CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 2 of 2
STEP 1:
1. Please put Chair Body (1) upside down on a carpeted or padded surface.
2. Attach Chair Base (2) to Chair Body (1) by using 4 pieces of Bolts (A), 4 pieces of Spring Washers (B)
and 4 pieces of Flat Washers (C). Tighten Bolts (A) by using Allen Wrench M6 (D) as shown in Figure 1.
3. Use Allen Wrench M8 (E) to tighten bolt (pre-assembled) in the middle of the Chair Base (2) as shown
in Figure 2.
STEP 2:
1. Carefully turn over the Chair.
2. Put Seat Cushion (3) into the Chair Body (1) as shown.
Assembly is complete. Your Chair is ready to enjoy now!
Attention:
Please adjust chair level
by adjustable pin.