modway EEI-2253 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2253 BAR TABLE
Hardware:
Component:
A Bolt M6x20mm x4
B
E Allen Wrench M4 x1
1 Table Top x1
Thank you for purchasing the MODWAY BAR TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
Bolt M6x25mm x6
2 Leg x2
C Bolt M6x20mm x8
D Flat Washer x8
F Allen Wrench M5 x1
2
3 Bottom Stretcher x1
3

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2253 BAR TABLE
2
B
A
E
2
1
3
2
2 E
D
D
F
B
E
2 1
STEP 1:
Ax4 Bx6 Fx1 Cx8 Dx8 Ex1 Hardware & Tool required
STEP 2:
1
Assembly is completed. The table is ready to enjoy now!
Carefully turn over the assembled table.
C
C
2
Please put the Table Top (1) upside down on a carpeted or padded area.
Remove the plastic covers which pre-install in the end of the Table Top (1) by using Allen Wrench (E/F).
Insert 1 piece of Leg (2) into Table Top (1) and bottom Stretcher (3) as shown.
Insert 2 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Table Top (1) into each side on the bottom of Leg (2).
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the side rail of the Table Top (1) into each end of Leg (2) as shown.
Insert 4 pieces of Bolt (C) with 4 pieces of Flat Washer (D) from the pre-drilled holes on the side of the Table Top (1)
into each end of Leg (2) as shown.
Insert 1 piece of Bolt (B) from the pre-drilled holes on the bottom of the Bottom Stretcher (3) into the Leg (2) as shown.
Do not fully tighten Bolts (A&B&C) at this step.
Repeat the same steps for the remaining 1 piece of Leg (2).
Use Allen Wrench (E) to tighten all Bolts (A&B) and Allen Wrench (F) to tighten all Bolts (C) clockwise until secure.