modway EEI-3900 User manual

EEI-3900 OFFICE CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 1of 4
Thank you for purchasing the MODWAY OFFICE CHAIR!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all the pieces out of reach of children.
Hardware:
Components:
Bolt M6x30mm x6
1. Base x1 2. Cylinder Column x1 3. Castor x5 4. Chassis x1
A.
Allen Wrench x1
5. Seat x1 6. Back x1 7. Armrest x2
C.
Flat Washer x4
D.
Bolt M6x22mm x4
B.

EEI-3900 OFFICE CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 2of 4
STEP 1:
1. Please put Seat (5) upside down on a carpeted or padded surface.
2. Attach 2 pieces of Armrests (7) to the Seat (5) by using 6 pieces of Bolts (A) as shown and use Allen
Wrench (D) to tighten all Bolts (A) clockwise as shown.
STEP 2:
Attach Chassis (4) to the Seat (5) by using 4 pieces of Bolts (B) and 4 pieces of Flat Washers (C) as
shown and use Allen Wrench (D) to tighten all Bolts (B) clockwise as shown.

EEI-3900 OFFICE CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 3of 4
STEP 3.
1. Please put Base (1) on a carpeted or padded surface.
2. Insert 1 piece of Castor (3) into the Base (1) as shown by hand.
3. Repeat the same steps for the remaining 4 pieces of Castors (3).
4. Carefully turn over the assembled Base (1) and Insert the Cylinder Column (2) as shown.
STEP 4:
Carefully turn over the assembled Seat (5) and Insert Chassis (4) into the Cylinder Column (2) as shown.

EEI-3900 OFFICE CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 4of 4
STEP 5:
Insert Back (6) into the Chassis (4) as shown.
Your office chair is ready to be used now!
Attention:
When you use the handle to
adjust the height to be lower,
please move away your feet
from the base at the same time.