modway EEI-3425-NAT-WHI User manual

EEI-3425-NAT-WHI ARMCHAIR
Customer Service 908-368-1025︱www.modway.com Page 1 of 3
Hardware:
A Bolt M6x50mm x 8
B
Allen Wrench M4 x 1
Component:
Thank you for purchasing the MODWAY ARMCHAIR!
1. Chair Back
3. Left Frame
4. Right Frame
5. Seat Cushion
6. Back Cushion
2. Chair Seat
x1
x1
x1
x1
x1
x1
1
2
3
4
5
6
Before you start, here are some helpful advice:
We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
Owing to the size and weight of the armchair, we recommend that it is assembled by two adults,
on a carpeted or padded area, in the room that it is intended for. Approximate assembly
time: 30 minutes.
Please do not use any tools other than those provided or recommended in these instructions.
Please do not throw away any of the packaging or instructions until you have checked all
the components and hardware and the furniture is fully assembled.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary
to tighten the components from time to time, so please save the tools that have been provided.
Please keep all pieces out of reach of small children.
1.
2.
3.
4.
5.
6.

EEI-3425-NAT-WHI ARMCHAIR
Customer Service 908-368-1025︱www.modway.com Page 2 of 3
STEP 1:
2
1
3
4
- Insert the rabbet on the Left Frame (3) into the tenon on Chair Seat (2) and Chair Back (1) at first.
- Repeat the same steps for the Right Frame (4).
Please assemble Chair Seat first including the Support Wooden.
Ax8 Bx1
2
4
1 3
Hardware & Tool required
1
1
2
2
3
3
STEP 2:
Repeat the same steps for Left Frame (3).
Insert 3 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1), and Chair Seat (2),
through the top pre-drilled holes on Right Frame (4). Use Allen Wrench (B) to tighten Bolts (A) clockwise until secure.
- Insert 2 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1).
-

EEI-3425-NAT-WHI ARMCHAIR
Customer Service 908-368-1025︱www.modway.com Page 3 of 3
STEP 3:
Put Back Cushion (5) and Seat Cushion (6) into the assembled chair as shown.
Carefully position the assembled chair to the desired location.
5
6
Assembly is complete. Your armchair is ready to be used now!