modway Shore EEI-2256 User manual

Customer Service 609-256-9000︱www.modway.com Page 1 of 2
EEI-2256 BAR TABLE
Hardware:
Component:
ABolt M6x20mm x20
B
CAllen Wrench M4 x1
1 Table Top x1
Thank you for purchasing the MODWAY BAR TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
Bolt M6x25mm x8
3Bottom Stretcher x2
2
3
3
2Leg x2

Customer Service 609-256-9000︱www.modway.com Page 2 of 2
EEI-2256 BAR TABLE
STEP 1:
Remove the plastic covers which pre-install in the end of the Table Top (1) by using Allen Wrench (C).
Please Stand 1 piece of Leg (2) on a carpeted or padded area.
Insert 1piece of Table Top (1) and 2 pieces of Bottom Stretcher (3) to the leg (2)as shown.
Insert 4 pieces of Bolts (B) from the pre-drilled holes on the bottom of the Table Top (1) into each side on the bottom of Leg (2).
Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Table Top (1) into each end of Leg (2) as shown.
Insert 8 pieces of Bolts (A) from the pre-drilled holes on the side of the Table Top (1) and Bottom Stretcher (3) into
the Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for the remaining 1 piece of Leg (2). Use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
Assembly is completed. The table is ready to enjoy now!

STEP 2:
Carefully turn over the assembled table.