modway EEI-3432 User manual

EEI-3432 CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 1of 2
Thank you for purchasing the MODWAY CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all the pieces out of reach of children.
Hardware:
Components:
Bolt M8x60mm x4
Flat Washer x4
1. Chair Body x1 2. Chair Base x1
A.
C.
Allen Wrench x1
B.

EEI-3432 CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 2of 2
STEP 1:
1. Please put Chair Body (1) upside down on a carpeted or padded surface.
2. Attach Chair Base (2) to Chair Body (1) by using 4 pieces of Bolts (A) and 4 pieces of Spring Washers (B)
with the wider part of Chair Base (2) in front of Chair Body (1) as shown.
(Note: the wider side is the front of the chair, the narrower side is the back of the chair.)
3. Use Allen Wrench (C) to tighten all Bolts (A) clockwise as shown.
STEP 2:
Carefully turn over the assembled chair and smooth the fabric cover to be good looking.
Note: The fabric cover is washable and fixed by velcro, please insert the fabric cover into seat and smooth it
again after wash it.
Assembly is complete. Your Chair is ready to enjoy now!