modway Ripple EEI-1532 User manual

EEI-1532/ EEI-1533 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 1 of 3
Thank you for purchasing the MODWAY OFFCIE CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Components:
1. Base x1 2. Cylinder Column x1
3. Castor x5 4. Back with Control Mechanism x1
EEI-1532 EEI-1533

EEI-1532/ EEI-1533 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 2 of 3
STEP 1:
1. Please put Base (1) upside down on a carpeted or padded surface.
2. Insert 5 pieces of Castors (3) into the Base (1) as shown by hand.
3. Carefully turn over the assembled Base (1) and insert the Cylinder Column (2) as shown.
STEP 2:
Insert Back with Control Mechanism (4) into the Cylinder Column (2) as shown

EEI-1532/ EEI-1533 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 3 of 3
STEP 3:
Assembly is complete. Your office chair is ready to be used now!
Attention: When you use the handle to adjust
the height to be lower, please move away
your legs from the base at the same time.