modway EEI-4074 User manual

EEI-4074 & 4075 TABLE
Customer Service 609-256-9000︱www.modway.com
Page 1of 3
Thank you for purchasing the MODWAY SIDE TABLE.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the Top and Base, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
TOP SKU LIST: EEI-1115, EEI-1116, EEI-1122, EEI-1123, EEI-1124, EEI-1128, EEI-1129, EEI-1136, EEI-1139, EEI-1140, EEI-1117,
EEI-1118, EEI-1125, EEI-1130, EEI-1131, EEI-1137, EEI-1832, EEI-1833, EEI-1834
Flat Washer x4
1. Top x1 2. Fixing Plate x1 3. Pole x1 4. Base x1
C.
Bolt M8x30mm x6
A.
Bolt M8x18mm x4
B.
D.
Allen Wrench x1

EEI-4074 & 4075 TABLE
Customer Service 609-256-9000︱www.modway.com
Page 2of 3
STEP 1:
1. Take out the hardware package from the carton of Base (4).
2. Adjust each three holes at the bottom of Pole (3) and Base (4) to be matched, then insert 3 pieces of
Bolts (A) into the matched holes of the bottom of Pole (3) and Base (4) as shown.
3. Use Allen Wrench (D) to tighten all Bolts (A) clockwise as shown.
STEP 2:
1. Carefully turn over the assembled Pole (3) and Base (4).
2. Adjust each three holes of Fixing Plate (2) and Pole (3) to be matched, then insert 3 pieces of Bolts (A) into
the matched holes of Fixing Plate (2) and Pole (3) as shown.
3. Use Allen Wrench (D) to tighten all Bolts (A) clockwise as shown.

EEI-4074 & 4075 TABLE
Customer Service 609-256-9000︱www.modway.com
Page 3of 3
STEP 3:
1. Please put Top (1) upside down on a carpeted or padded surface.
2. Adjust each four holes of the bottom of Top (1) and Fixing Plate (2) to be matched, then insert 4 pieces of
Bolts (B) with 4 pieces of Flat Washers (C) into the matched holes of the bottom of Top (1) and
Fixing Plate (2) as shown.
3. Use Allen Wrench (D) to tighten all Bolts (B) clockwise as shown.
STEP 4:
Carefully turn over the assembled table.
Assembly is complete. Your table is ready to enjoy now!