modway EEI-2279 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2279 SWING CHAIR
Hardware:
Components:
A Bolt M10x60mm x2
B
C Spring x1
1 Chair Base x1
Thank you for purchasing the MODWAY SWING CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 15 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
3
Nut M10 x2
1
3 Basket Frame x1
2 Stand x1
D Spring Holder x1
F Open Wrench x1
E Allen Wrench x1
4 Cushion x1
4
and then follow the simple step-by-step

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2279 SWING CHAIR
STEP 1:
Ax2 Bx2 Cx1 Dx1 Ex1 Fx1 Hardware & Tool required
Assembly is completed. The swing chair is ready to enjoy now!
Please put all chair parts on a carpeted or padded area.
Find the hardware package inside of the tube on Chair Base (1).
Insert Stand (2) into Chair Base (1) as shown.
Secure by using 2 pieces of Bolt (A) with 2 pieces of Nut (B). Note: Bolt (A) should be inserted by the left side.
Use Allen Wrench (E) and Open Wrench (F) to tighten Bolts (A) and Nuts (B) clockwise until secure.
STEP 2:
Insert Spring Holder (D) into the pre-drilled hole at the top of Stand (2) as shown.
Hang Basket Frame (3) to Stand (2) by using 1 piece of Spring (C) as shown.
Place Cushion (4) to Basket Frame (3) as shown.
Note: Hardware package is
packed inside of the base tube.
1
2
3
D
C
A
B
A
B
Maximum Weight: 120 KG
STEP 1
STEP 2
4