modway EEI-4526 User manual

EEI-4526、EEI-4527 BAR STOOL / 4528、EEI-4529 COUNTER STOOL
Customer Service 609-256-9000︱www.modway.com Page 1 of 3
Thank you for purchasing the MODWAY counter/bar stool.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the counter/bar stool, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
STEP 1:
1. Please put Body (1) upside down on a carpeted or padded surface.
Bolt M8x30mm x8
Flat Washer x8
1. Body x1 2. Front Leg x1 3. Back Leg x2 4. Stretcher x1
A.
E. Allen Wrench M8 x1
D.
Spring Washer x8
C.
Bolt M6x16mm x4
B.
F. Allen Wrench M6 x1

EEI-4526、EEI-4527 BAR STOOL / 4528、EEI-4529 COUNTER STOOL
Customer Service 609-256-9000︱www.modway.com Page 2 of 3
2. Attach 2 pieces of Front Legs (2) to the front of Body (1) by using 4 pieces of Bolts (A) with 4 pieces
of Spring Washers (C) and 4 pieces of Flat Washers (D) as shown.
3. Attach 2 pieces of Back Legs (3) to the back of Body (1) by using 4 pieces of Bolts (A) with 4 pieces
of Spring Washers (C) and 4 pieces of Flat Washers (D) as shown.
4. Use Allen Wrench (E) to tighten all Bolts (A) as shown, Don’t tight Bolts (A) fully.
STEP 2:
1. Attach Stretcher (4) to Front Legs (2) and Back Legs (3) by using 4 pieces of Bolts (B) as shown.
2. Use Allen Wrench (F) to tighten Bolts (B) as shown.Don’t tight all Bolts (B) fully.
4. When Stretchers (4) are fixed, please fully tighten all Bolts (A) and all Bolts (B).
STEP 3:
Carefully turn over the assembled counter/bar stool.

EEI-4526、EEI-4527 BAR STOOL / 4528、EEI-4529 COUNTER STOOL
Customer Service 609-256-9000︱www.modway.com Page 3 of 3
Assembly is complete. Your counter/bar stool is ready to enjoy now!
Attention:
If the counter/bar stool is not stable,
you may adjust it by alignment pin.