modway MOD-5552 User manual

Center Rail
Support Leg
MOD-5552/5553 FULL/QUEEN BED
Short
Medium
Long
step by step
are
imately

Double S;lats (4)
’
MediumM Bolts (B)
Support Legs (6 )
Open Wrench 9( ).
Allen Wrench (G)
Double S;lats(4)
Hardware & Tool required
7
D
G
B
6
H
MOD-5552/5553 FULL/QUEEN BED
.
.
STEP 2:
4
4
4
7
Cx4 Dx4 Gx1 Hx1
7
Bx4 Dx4
Gx1 Ex1
66
6
6
6
6
6
6
Hardware & Tool required
G
C
B
76
H
Insert 4 pieces of into the 4 holes on Center Rail (7) as shown.
Please pay attention to the holes direction.
Tighten with Nut (D) by using Allen Wrench (G) and Open Wrench ( ) untll secure.
to connect it with
Take out all and place them as shown.
Attach to the Center Rail (7) by using Bolts (C) and Nuts (D).
Do not fully tighten
Long Bolts (C) and Nuts (D) with and
Please pay attention to the holes ’
direction on the
Long Bolts (C)
at this step.
Tighten
E
E
Double S;lats(4).
D
6
Medium M Bolts (B)

Bolts(A& C)
Allen Wrench (G).
Short Bolts (A)
Double Slats (4)
RUubber Insert (F)
Single Slats% (5)
Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
MOD-5532/5533 FULL/QUEEN BED
A
G
STEP 4:
Insert Bolts (A) into the bottom holes on the assembled Headboard (1) & Footboard
(2) by hand.
Leaving 0.3~0.4inch space of the thread of Bolts (A) as shown.
Insert the notch of assembled Side Rails (3) into the space left on the Bolts (A).
Screw Bolts (A) into the top holes on the assembled Headboard (1) & Footboard (2) as shown.
Tighten Bolts (A) with Allen Wrench (G) after all assembled.
AX8 Gx1 Hardware & Tool required
6
3
6
A 3 6
A
6
6
2
1
Top Hole
Bottom Hole
Notch
3
3
Assembly is complete. Your bed is ready to be enjoyed now!
0.3~0.4inch
STEP 3:
.
Hardware & Tool required
4
4
4
4
7
6
3
3
5
5
3
4
A
AG
Ax16 Gx1
5
F
.
Take out and place them as shown.
Insert one end of into , then insert them into the crossponding
holes on 1 piece of Side Rail (3) as shown.
Attach assembled to the Side Rail (3) by using 2 pieces of with
Repeat above for the other
Side Rail (3).
Don’t fully tighten
Short Bolts (A) at this step.
Single Slats% (5)
Please fully tighten all .
at this step.
'
&