modway EEI-2140 User manual

EEI-2140 ARMLESS SOFA
Thank you for purchasing the MODWAY ARMLESS SOFA!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by step instructions.
2. Owing to the size and weight of the sofa, we recommend that it is assembled by two adults on a carpeted or
padded area, in the room that it is intended for. Approximate time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
component from time to time,so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Components:
1. Back Cushion x1 2. Seat Cushion x1 3.Sofa Body x1 4. Leg x4
Customer Service 908-368-1025 I www.modwayfurniture.com Page 1 of 3

EEI-2140 ARMLESS SOFA
STEP 1:
Please put the Sofa Body (3) upside down on a carpeted or padded area by two adults to make the corners
fully visible. Open the Zipper on the bottom of Sofa Body (3) as shown, take out the packages of Legs (4), then close
the Zipper on the bottom of Sofa Body (3) . Take off the black protection cover on the Legs (4).Insert 1 piece
of Leg (4) into the bottom of Sofa Body (3) as shown. Use hands to tighten the Leg (4) clockwise until secure.
Repeat the same steps for the other three pieces of Leg (4).
STEP 2:
Carefully turn over the assembled Sofa Body (3) as shown. Tear off the Protect film attached onto the Velcro at first .
Then place the Back Cushion (1) and Seat Cushion (2) to the assembled Sofa Body (3) as shown.
Attach the Seat Cushion (2) by using Velcro.
Assembly is complete.The Armless sofa is ready to enjoy now!
Customer Service 908-368-1025 I www.modwayfurniture.com Page 2 of 3
x 4PCS
Black Protection Cover
Legs inside

EEI-2140 ARMLESS SOFA
STEP 3:
If you want the armless sofa combine with other section, put the assembled Sofa Body (3) upside down on
a carpeted or padded area. Screw the Clip into the bottom of sofa right end by using screws.Using a Phillips head
screw driver to tighten the screws. Repeat the same steps for the Post.
STEP 4:
Please place the Left Section at your desired location.
Align the Past on the bottoms of Left Section to the Clip on the bottom of Armless Sofa as shown at first.
Push the Armless Sofa close to the Left Section slowly until the Clip and the Post click together tightly.
Then align the Clip on the bottom of Right Section to the Post on the bottom of Armless Sofa.
Push the Right Section close to the Armless Sofa slowly until the Clip and the Post click together tightly.
If you want to unlock the sofa. Please lift up the Armless Sofa By two adults.
Customer Service 908-368-1025 I www.modwayfurniture.com Page 3 of 3