modway Shore EEI-2254 User manual

Customer Service 609-256-9000︱www.modway.com Page 1 of 2
EEI-2254 ARM BARSTOOL
Hardware:
Component:
ABolt M6x20mm x6
BAllen Wrench M4 x1
1 Barstool body x1
Thank you for purchasing the MODWAY BARSTOOL！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the barstool, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
2 Bottom Stretcher x1

Customer Service 609-256-9000︱www.modway.com Page 2 of 2
EEI-2254 ARM BARSTOOL
STEP 1:
Please put the Barstool Body (1) on a carpeted or padded area.
Place Bottom Stretcher (2) to Barstool Body (1) as shown.
Insert 4 pieces of Bolts (A) from the pre-drilled holes at Bottom Stretcher (2) into the pre-drilled holes at leg posts
on Barstool Body (1).
Insert 2 pieces of Bolts (A) from the pre-drilled holes at Bottom Stretcher (2) into the pre-drilled holes at front stretcher
on Barstool Body (1).
Use Allen Wrench (B) to tighten all Bolts (A) clockwise until secure.
STEP 2:
Assembly is completed. The barstool is ready to enjoy now!
Carefully place the barstool at your desired position.