modway TWIN BED FRAME MOD-5430 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
MOD-5430 TWIN BED FRAME
Component:
1 Short Board x2
Thank you for purchasing the MODWAY TWIN BED FRAME！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed frame, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
1
1
2
2
3
3
3
3
4
2 Long Board x2 3 Leg x4
4 Slat x12
Hardware:
B Metal Support x4
A Bolt M8x20mm x24
C Side Plastic Cover x24
D Allen Wrench x1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
MOD-5430 TWIN BED FRAME
Ax16 Dx1
STEP 1:
Please put Short Boards (1), Long Boards (2) upside down on a carpeted or padded area.
Attach 1 piece of Metal Support (B) to one corner of Short Boards (1) and Long Boards (2) by using 2 pieces of
Bolt (A) as shown.
Repeat the same steps for the remaining 3 pieces of Metal Support (B).
Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure.
STEP 2:
Attach 1 piece of Leg (3) to one corner of Short Boards (1) and Long Boards (2) by using 4 pieces of Bolt (A) as shown.
Repeat the same steps for the remaining 3 pieces of Leg (3).
Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure.
Hardware & Tool required
Ax8 Bx4 Dx1 Hardware & Tool required
1
1
2
2
1
2
B A
D
A
A
B
1
2
2
1
3
3
3
3
A
D
A
A
A
3
2 1
B
A
A
A
A
A

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
MOD-5430 TWIN BED FRAME
Ax24
STEP 3:
Insert 2 piece of Side Plastic Cover (C) into each end of Slat (4) as shown.
Insert the assembled Side Plastic Covers (C) into the corresponding holes on Long Board (2) as shown.
Repeat the same steps for the remaining 11 pieces Slat (4).
Hardware & Tool required
2
2
4
C
C
Assembly is complete. Your bed frame is ready to be used now!