modway EEI -2776 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI –2776 CHAIR
Thank you for purchasing the MODWAY CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
Hardware:
A
D Allen Wrench M5 x1
Components:
1 Chair Leg x4
2
Chair Body x1
Flat Washer M8 x8
Bolt M8 x35mm x8
B
Back Cushion x1
3
3
1
2 2
Screw M4x25mm x8
C
Phillips Head Screwdriver
( Not included)

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI –2776 CHAIR
STEP 1:
STEP 2:
Put Chair Body (1) upside down on a carpeted or padded surface.
Place 1 piece of Chair Leg (2) to the bottom of Chair Body (1) as shown.
Insert 2 pieces of Bolts (A) with 2 pieces of Flat Washers (B) into the pre-drilled holes on Chair Body (1) through the pre-drilled
holes on Chair Leg (2).
Insert 2 pieces of Screws (C) into the bottom of Chair Body (1) through the pre-drilled holes on Chair Leg (2).
Use Allen Wrench (D) to tighten Bolts (A) and Phillips Head Screwdriver (Not provided) to tighten Screws (C) clockwise
until secure.
Repeat the same steps for the remaining Chair Legs (2)..
Hardware & Tools required
Ax8 Bx8 Cx8 Dx1
Phillips Head Screwdriver
( Not included)
1
Assembly is complete. Your chair is ready to be used now!
Carefully turn over the assembled chair.
Put Back Cushion (3) to the assembled Chair Body (1) as shown.
1
3
2
2 2
2
2
C
C
B
A
A
B
D
C
A
A
C
A A
C
C
C
C
A A
A
A
C
C