MojoDesk Hand Control 2020 User manual

MojoDesk 2020 Hand Control
Operation Instructions
1. Product Drawing
2. Button Functions
Button functions: There are seven buttons "▲" , "▼" , "1" , "2" , " "" " "M"
1. "▲" : Adjust the desk upwards
2. "▼" : Adjust the desk downwards
3. "1" : Position 1, first height position saved by the user
4. "2" : Position 2, second height position saved by the user
5. " " : Position 3, the standing height saved by the user
6. " " : Position 4, the seated height saved by the user
7. "M" : Memory saving button, for height memory function and Child lock: for security
LED Height Display

Waste disposal
This marking indicates that this product should not be disposed with other household
wastes. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
●Troubleshooting:
a. Reset: When the LED shows "  " , press “▼” button until the desk reaches its
lowest height and rebounds to stop, the reset has been finished.
b. If LED shows "E01" or "E02", please retry 18 mins later, desk overuse.
c. If the “▼” button doesn't work, please check cable connections and then unplug
power for at least 10 seconds. Reconnect power and press “▼” button to start the reset
process when it shows the "  ".
d. Still not working?, please contact MojoDesk customer service 800-297-6656.
3. Operating Instructions
●Height Adjustment:
Press the"▲" or "▼" button to adjust the height. The LED display shows the current height.
Set Memory Positions:
a. Press the "▲" or "▼" button to adjust to the desired height
b. Press and release "M" to enter memory setting mode and the screen will display " "
c. Press 1, 2, " ", or, " " to save the height to the corresponding position which will
show in the display screen as " " ," ", or " ", or " ";
Move to Memory Positions:
Press and release the "1", "2", " ", or " " button to automatically adjust to the saved
position.
●
●Anti-collision sensitivity adjustment - optional:
Press and hold the “▲” “▼” buttons for 5 seconds at the same time to switch the
sensitivity. Once the display shows " #" it has cycled to the next setting. Release
buttons and repeat to cycle through settings.
“ ”, the anti-collision function is off; " ", low sensitivity
“ ", medium sensitivity; " ", high sensitivity (default)
●
Anti-collision: During height adjustment, if tabletop comes in contact with another
object, it instantly stops and reverses to avoid damage.
●
Child lock function:
a. To engage or disengage child lock, press and hold the M button for about 5 seconds.
b. When child lock is turned on, a blue LED light activates above "▼" and M. Any button
press creates a flash of the blue LED, a beep and LOC on the display
c. Only when the child lock is unlocked, will all the buttons work normally.
●