Monoprice Blackbird 4K Pro HDBaseT User manual

Blackbird™4K Pro HDBaseT™Extender Kit
P/N 31059
User's Manual

2
SAFETY WARNINGS AND GUIDELINES
Please read this entire manual before using this device, paying extra attention to these
safety warnings and guidelines. Please keep this manual in a safe place for future reference.
This device is intended for indoor use only.
Do not expose this device to water or moisture of any kind. Do not place drinks or
other containers with moisture on or near the device. If moisture does get in or on
the device, immediately unplug it from the power outlet and allow it to fully dry
before reapplying power.
Do not expose this device to excessively high temperatures. Do not place it in, on,
or near heat sources, such as a fireplace, stove, radiator, etc. Do not leave it in direct
sunlight.
Do not place or install this device in an area where it can be exposed to excessive
amounts of dust, humidity, oil, smoke, or combustible vapors.
Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
Before plugging the unit into a power outlet, ensure that the outlet provides the
same type and level of power required by the device.
Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
Ensure that power is turned off and disconnected before making any electrical
connections.
Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or
detergents. For stubborn deposits, moisten the cloth with warm water.
This device has no user serviceable parts. Do not attempt to open, service, or
modify this device.

3
INTRODUCTION
This Blackbird™ 4K Pro HDBaseT™ Extender Kit is an ideal solution for extending HDMI®
video signals over long distances. It can extend a 4K@60Hz 4:2:0 signal to distances up to
230 feet (70 meters) or a 1080p@60Hz signal to distances up to 328 feet (100 meters) over
a single Cat6 Ethernet cable. It delivers 10.2 Gbps bandwidth and supports bi-directional IR
and RS-232 signal pass-through. It also supports the Power over Cable (PoC) feature, which
allows either unit to obtain power over the Ethernet cable from the other unit. It is
compliant with the HDMI 1.4 and HDCP 2.2 specifications.
FEATURES
Extends 4K@60Hz 4:2:0 HDMI® signals to distances up to 230 feet (70 meters) over a
single Cat6 Ethernet cable
Extends 1080p@60Hz HDMI signals to distances up to 328 feet (100 meters) over a
single Cat6 Ethernet cable
Supports bi-directional IR and RS-232 pass-through extension
Supports bi-directional Power over Cable (PoC) for simplified wiring
Compliant with the HDMI 1.4 and HDCP 2.2 specifications
CUSTOMER SERVICE
The Monoprice Customer Service department is dedicated to ensuring that your ordering,
purchasing, and delivery experience is second to none. If you have any problem with your
order, please give us an opportunity to make it right. You can contact a Monoprice
Customer Service representative through the Live Chat link on our website
www.monoprice.com during normal business hours (Mon-Fri: 5am-7pm PT, Sat-Sun: 9am-
6pm PT) or via email at [email protected]om

4
PACKAGE CONTENTS
Please take an inventory of the package contents to ensure you have all the items listed
below. If anything is missing or damaged, please contact Monoprice Customer Service for a
replacement.
1x HDBaseT™ transmitter
1x HDBaseT receiver
4x Mounting brackets
4x Screws
8x Plastic feet
2x 3-pin Euroblock connectors
1x AC power adapter (12 VDC, 1A)
1x User's manual
PRODUCT OVERVIEW
Transmitter
1. HDMI IN: HDMI® port for connecting the video source device.
2. IR IN: 3.5mm jack for connecting an IR receiver (not included).
3. IT OUT: 3.5mm jack for connecting an IR transmitter (not included).
4. RS-232: 3-pin Euroblock connector for connecting to a computer for pass-through
RS-232 signals or to update the transmitter.
5. DC 12V: DC barrel connector for connecting the included AC power adapter.

5
6. POWER LED: The LED illuminates red when power is applied.
7. HDBT OUT: RJ45 connector for connecting a Cat6 Ethernet cable to connect with
the receiver.
8. CTRL/UPDATE: Switch to determine the behavior of the RS-232 connection. When in
the CTRL position, the transmitter will pass RS-232 signals on to the receiver for
control of a connected device. When in the UPDATE position, you can update the
Valens IC program by connecting to a PC and running a batch file.
Receiver
1. HDMI OUT: HDMI® port for connecting an HDMI display.
2. IR IN: 3.5mm jack for connecting an IR receiver (not included).
3. IT OUT: 3.5mm jack for connecting an IR transmitter (not included).
4. RS-232: 3-pin Euroblock connector for connecting to a computer for pass-through
RS-232 signals or to update the transmitter.
5. DC 12V: DC barrel connector for connecting the included AC power adapter.
6. POWER LED: The LED illuminates red when power is applied.
7. HDBT IN: RJ45 connector for connecting a Cat6 Ethernet cable to connect with the
transmitter.
8. CTRL/UPDATE: Switch to determine the behavior of the RS-232 connection. When in
the CTRL position, the transmitter will pass RS-232 signals on to the transmitter for
control of a connected device. When in the UPDATE position, you can update the
Valens IC program by connecting to a PC and running a batch file.

6
SAMPLE CONNECTION DIAGRAM
TECHNICAL SUPPORT
Monoprice is pleased to provide free, live, online technical support to assist you with any
questions you may have about installation, setup, troubleshooting, or product
recommendations. If you ever need assistance with your new product, please come online
to talk to one of our friendly and knowledgeable Tech Support Associates. Technical
support is available through the online chat button on our website www.monoprice.com
during regular business hours, 7 days a week. You can also get assistance through email by
sending a message to [e-mail]

7
SPECIFICATIONS
Model
31059
Maximum Resolution
4K@60Hz 4:2:0
Bandwidth
10.2 Gbps
HDMI Version
1.4
HDCP Version
2.2
Transmission Method
HDBaseT™
Transmission Distance
4K@60Hz: up to 230 feet (70 meters)
1080p@60Hz: up to 328 feet (100 meters)
Control Pass-Through
Bi-directional IR and RS-232
Input Power
12 VDC, 1A or Power over Cable (PoC)
AC Adapter Input Power
100 ~ 240 VAC, 50/60 Hz
Maximum Power Consumption
10 watts
Operating Temperature
+14 ~ +122°F (-10 ~ +50°C)
Relative Humidity
0 ~ 90% RH, non-condensing
Dimensions (each)
4.7" x 2.9" x 0.6" (120 x 74 x 16 mm)
Weight (each)
8.5 oz. (240 g)
Blackbird™ is a trademark of Monoprice Inc.
HDBaseT™ and the HDBaseT Alliance logo are trademarks of the HDBaseT Alliance.
HDMI®, the HDMI Logo, and High-Definition Multimedia Interface are trademarks or
registered trademarks of HDMI Licensing LLC in the United States and other countries.
Blu-ray Disc™ and Blu-ray™ are trademarks of the Blu-ray Disc Association.