Monoprice MP-DLB401 User manual

Item No.:MP-DLB401
INSTALLATION GUIDE
-4-
Thank you for choosing our product
This product contains small items that could be a choking hazard if swallowed. Keep
these items away from young children
1.Make sure these instructions are read and completely understood before attempting
installation. If you are unsure of any part of this installation, contact a professional
installer for assistance.
2.The wall or mounting surface must be capable of supporting the combined weight of
the mount and the display; otherwise the structure must be reinforced
3.Safety gear and proper tools must be used. A minimum of two people are required
for this installation. Failure to use safety gear can result in property damage, serious
injury or death.
!
.
Warning
CAUTION
Please read this guide before installation.
Ensure the correct installation. Keep away from high frequency or power equipment to
avoid disturbance.Choose desk to put this product.
We can not be responsible for any damage caused by wrong installation.
TV Size Range: 10 24
Max load capacity of each TV plate 22lbs
Integrated Cable management
""
:
~

-2- -3-
Hardware Kit:Hardware Kit:
Part 1
thick
Choose the position of the base you want
installed. Make sure there is enough space to
spread display considering the show size.
The desk should between 15mm to 55mm
and strong enough to bear the force
caused by your display.
-Fitting the botton support on the desk
Part 1-Fitting the botton support on the desk
M6X10mm bolt
Part 2-Attach TV to adapter plate
Attach TV to adapter plate using eight selected screws(A-D) and washers(E).
Tighten screws firmly. Do not overtighten.
Part 2-Attach TV to adapter plate
Adapter Plate
ABCDE
A
B
C
M4×8mm bolt
M ×12mm4 bolt
M ×8mm5 bolt
M5×12mm bolt
M5 washer
D
4
4
4
4
4
E
A-D
E
Top Cover
Hand handle
Plastic cover
Knob
Tube
Bottom support
M6X10mm bolt
Part 3 Attaching Adapter Plate
Attach adapter plate to tube by sliding flanges of adapter plate into flanges
of tube. then cover the top cover using bolt by wrench.
Part 3 Attaching Adapter Plate
Wrench