montpellier MHG600X User manual

Cod:0103086952-00.02
60 /70 /90
MHG600X/BK - Stainless or Black
MHG700X/BK - Stainless or Black
MHG900X - Stainless

Thank you for choosing this Montpellier &XUYHG*ODVV&RRNHU+RRG.
Our +RRGVhaYH been designed to provide you with the best combination of style, reliability and performance to
give you years of trouble-free use.
You may be familiar with a similar product, but please take time to read these instructions carefully before installing
or using your &RRNHU+RRG to ensure you get the most from your purchase.
We recommend that you keep this manual in a safe place for future reference.
Your &RRNHU+RRGis covered by a comprehensive two year Parts & Labour
Guarantee. In the unlikely event that you experience a problem with your +RRG,
you can rest assured that you are fully protected against WKHFRVWRIUHSDLUVIRU
WKHILUVWPRQWKV3OHDVHQRWHWKDWDQ\FODLPPXVWbe accompanied by the
model reference number, serial number and proof of purchase.
To activate your guarantee, you will need your product serial number. This can
be found on the rear of the machine.
There are two ways to register your Guarantee:
•Online: Visit the Support page on our website and complete the online Product
Registration form. www.montpellier-appliances.com
•By Post:6LPSO\GHWDFKDQGƮOOLQWKHIRUPSURYLGHGDWWDFKDVWDPSDQGVHQG
it in the post. Don’t forget to include your e-mail address so that we can send
FRQƮUPDWLRQWKURXJKWR\RX
Welcome
Note: We are unable to take registrations over the phone.
ACROSS ALL OUR MODELS
YEAR
GUARANTEE
PA R T S & LA B O U R
www.montpellier-appliances.com


Using your Extractor
For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run
for approximately 15 minutes after the end of cooking.
Control Panel
B –
C –
Press button C.
To switch on the extractor or change the motor speed at any time when the extractor is running
Press button B for the first, second or third speed as required.
Press button A.
Fig. 1 ABC

Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING
OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE
ELECTRICITY SUPPLY.
Cleaning
hse a nonͲabrasivecleaner. Any abrasive cleaner (including Cif) will
scratch the surface and could erase the control panel markings.
solution of water and mild detergent and drying to a shine with a clean
cloth.
The grease filter should be kept clean to minimise the risk of fire.
zou should remove and clean the grease filter with hot soapy waterĂƚ
ůĞĂƐƚŽŶĐĞĂŵŽŶƚŚ.You can also wash the grease filter in a
dishwasher, ensuring that you place it in an upright position to prevent
damage from other items in the dishwasher.After rinsing and drying,
replace the filter.
To remove the grease filter, push in the button on the handle and then
pull down on the filter at the front. When you have released it at the
front, pull out the filter.To replace the grease filter, repeat the ĂďŽǀĞ
steps in reverse.
Please note:
Cleaning the grease filter in the dishwasher may lead to discolouration.
This is normal and does not constitute a fault with the appliance.
Fig. 2


6
NOTE: Replacement ofthe LED lamp must becarried out
by a qualified electrician.
IMPORTANT: DO NOT PERFORM MAINTENANCE
OR CLEANING OF THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY SUPPLY.
Please note that the LED lamp is not covered by the guarantee.
Remove the lamp using a flat-head screwdriver(Fig.4-I).
Pull out the lamp. Unplug the lamp wire connector. Replace the lamp
(Fig.4-II).
Plug the wire connector into the new lamp. Replace the new lamp in
the lamp holder. Push the LED lamp into
place (Fig.4-III).
The light is designed for use during cooking and not for general room
illumination. Extended use of the light can reduce its life span. Please
contact your local retailer in order to purchase a new LED lamp when
replacing a damaged or a faulty one.
1X1.5W LED MAX
Fig. 4-I
Fig. 4-II
Fig. 4-III

FUSE 5A
PROTECTION LINE
5A Fuse is installed inside the plug to protection line.
26.5W
7

5
6
A
B
C*
D
E
F
16
94
120
86.5
75
Height dependent
MHG600X / MHG600BK / MHG700X / MHG700BK
MHG900X
For best performance and lowest noise output, we recommend
use of 150mm ducting for MHG models.
observed. This is a legal requirement and may lead to your hob
being reported to RIDDOR (the height should be measured from
extractor installed above it.
C
E
F
D
Centre
B
A
Gas: 750mm recommend
Electric: 650mm recommend
8

INSTALLATION
8.giF7.giF
10.giF9.giF
11.giF
)2elbatees(deriuqersallawkraMderiuqerslooT
sgnixfiynatahterusnE-swercspotdnasgnixfillawtiFselohllirD
you use are appropriate for the wall type.
)swercsllanethgit(dooheruceS
IMPORTANT SAFETY WARNING: ONLY USE THE SCREWS PROVIDED WITH THE EXTRACTOR TO MOUNT
THE DUCTING ADAPTOR. THE USE OF LONGER SCREWS MAY CAUSE DAMAGE TO THE INTERNAL WIRING
WHICH WILL NOT BE COVERED BY THE WARRANTY.
8
10mm
9

Fig. 13
51.giF41.giF
)tniojlaes(gnitcudxiFstekcarbyenmihctnuoM
yenmihcehterucesdnatsujdAyenmihcehttnuoM
Fig. 12
The metal casing of this appliance has been coated with a preservative to protect it during transport and storage.
This should be removed during installation by using a non-abrasive stainless steel cleaner. Always follow the
instructions given with the cleaner being used.
10