Morphy Richards 3 slice Trio toaster User manual

3 slice Trio toaster
Dear Customer
Morphy Richards present the Trio 3 slice toaster, a
brand new concept in vari-width toasters. It has 3
extra wide, extra deep slots which can toast a wide
range of items, reflecting todays changing eating habits.
The Trio can toast 1, 2 or 3 slices of bread and its
vari-width slots can toast thick or thin slices. It can
toast one side only in the 2 outer slots - perfect for
burger buns and bagels. It also has a single slice facility
in the centre slot, which is ideal for quick snacks, and
saves heating the whole machine for just one slice.
The After Sales Division, Morphy Richards Ltd, Mexborough, South Yorkshire, England, S64 8AJ
Freephone (office hours): UK 0800 424848, Republic of Ireland 1800 409119
Please read the instruction book carefully before using your toaster, so you can gain
maximum benefit from your appliance.

2
IMPORTANT
SAFEGUARDS
1Read all instructions.
2Do not touch hot surfaces. Use
handles or knobs.
3To protect against fire and electrical
shock do not immerse cord, plug or
toaster itself in water or other liquid.
4Ensure that this toaster is situated out
of the reach of children. Children
should never be allowed to operate
this toaster.
5Unplug from outlet when not in use
and before cleaning. Allow to cool
before putting on or taking off parts.
6Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
damaged in any manner. Should you
require service, advice or repairs to
your toaster, please use the freephone
number.
This product contains no user-
serviceable parts.
7The use of accessory attachments not
recommended by the toaster
manufacturer may cause injuries.
8Do not use outdoors.
9Do not let cord hang over edge of
table or counter, or touch hot
surfaces.
10 Do not place on or near a hot gas or
electric burner, or in a heated oven.
11 Do not attempt to move your toaster
whilst hot.
12 When unplugging, turn any control to
off, then remove plug from wall outlet.
13 Do not use your toaster for other
than intended use.
14 Preheating of this toaster is not
required.
15 DO NOT TOUCH THE METAL TOP
RIM OF THE TOASTER DURING
OR AFTER USE AS THIS GETS
VERY HOT.
16 ENSURE THAT SUFFICIENT SPACE
IS LEFT ABOVE AND AROUND ALL
SIDES OF YOUR TOASTER TO
ALLOW AIR TO CIRCULATE. DO
WATCH YOUR TOASTER DURING
USE. A FIRE MAY OCCUR IF
TOASTERS ARE COVERED OR
TOUCHING FLAMMABLE
MATERIAL, INCLUDING CURTAINS,
DRAPERIES, WALLS, AND THE LIKE,
WHEN IN OPERATION.
17 Oversize foods, metal foil packages, or
utensils must not be inserted into a
toaster, as they may involve a risk of
fire or electric shock.
18 Do not attempt to dislodge food when
toaster is plugged in and never
introduce cooking utensils into the
slots.
19 Do not place bread or other
items on top of the bread slots as
this will damage your toaster and
creates a fire hazard.
Worth noting: If your toaster does
not work, check the following points:
20 Has the toaster been set correctly - is
the plug in its socket and the switch in
the ‘on’ position?
21 Is the plug itself or the socket faulty -
check this by plugging in another
appliance.
22 Does the fuse need replacing - if you
have fitted your own plug, are the
internal plug connections secure and
correctly made?
23 Do not lift or move the toaster by
inserting fingers in bread slots.
SAVE THESE
INSTRUCTIONS

Position 3
function
switch in
upper
position
Warning
We recommend that Pop Tarts and pitta breads are not used in the Trio toaster.
Please take time to read this useful information before using your 3 slice Trio toaster
Toasts 2 or 3 slices
Use this setting when toasting 2 or 3 slices of bread. This
function toasts both sides in all 3 slots. Ideal for:
•Normal sliced bread
•Thin slices
•Thick slices
•English muffins
•Fruit bread
•Crumpets
•Waffles
1 side only (in 2 outer slots)
This function toasts one side only. To prepare, slice the item
in half if required. Place the item(s) in the two outer slots
and proceed as normal, this is ideal for:
•Burger buns
•Bagels
•Fruit scones
•English muffins
•Crumpets
•Tea cakes
•Bread rolls
•Bread crusts
Position 1 1 slice only (centre slot)
If you wish to toast one slice of bread only, place the
bread in centre slot and proceed as normal. This function
toasts both sides in the centre slot, which is ideal for
quick snacks for any member of the family.
Position 1
function
switch in
lower
position

4
Electrical requirements
Check that the voltage on the rating plate of your
appliance corresponds with your house electricity
supply which must be A.C. (Alternating Current).
If the socket outlets in your home are not suitable
for the plug supplied with this appliance, the plug
should be removed and the appropriate one fitted.
Note: The plug removed from the mains lead, if
severed, must be destroyed as a plug with bared
flexible cord is hazardous if engaged into a live socket
outlet.
WARNING: THIS APPLIANCE MUST BE
EARTHED
Should the fuse in the 13 amp plug require
replacement, a BS1362 13 amp fuse must be fitted.
Features of your toaster
⁄Variable width bread slots
¤Electronic variable browning control
‹2 position function switch
›Frozen bread button
fiCancel button
flBread carriage lever/hi lift for small items
‡Removable crumb tray (at rear)
·Cord storage (on base)
Instructions for use
1Before plugging in ensure that the carriage lever
flis in the upper position.
2Use your toaster once without bread. This will
pre-heat the new elements and burn off any dust
which may have accumulated during storage.
3Select the desired level of browning on the
browning control ¤marked 1 to 8. You will need
to vary the setting according to the moisture
content and thickness of bread. For best results
ensure that the bread slices are of even thickness,
freshness and size. The variable width bread slots
will accept thicker or thinner bread than a
conventional toaster. Remember that stale bread
toasts more rapidly than fresh and thin bread
toasts quicker than thick. See the ‘additional
points’ section for more information.
4After selecting the desired setting, place your bread
in the slots and depress the bread carriage lever fl
downwards until it locks.
Note: The bread carriage lever will not stay down unless
the toaster is plugged in and wall switch is on.
5When the toast is cooked, it will pop-up
automatically ready for removal from the slots.
The bread carriage lever will have returned to its
upper position and disconnected the element,
ready for the next toasting.
•If the first slices are not dark enough turn the
browning control to a higher setting.
•If the first slices are too dark turn the browning control
to a lower setting.
• When toasting two slices, put the bread in the
two outer slots for best results. One side may
appear to be a darker colour than the other. This
is quite normal and is not a fault.
•If the bread in your toaster becomes jammed,
disconnect your toaster at the socket, allow it to
cool, then remove the bread.
•When not in use, switch
your toaster off at the mains
and remove the plug from
the socket. DO NOT
WRAP THE CABLE
AROUND THE MAIN
BODY OF THE TOASTER
DURING OR
IMMEDIATELY AFTER USE.
THE CABLE STORAGE
AREA UNDERNEATH THE
TOASTER SHOULD BE USED.
Please read before use, taking careful note
of points 1 to 3
›
‡
·
¤
⁄
fi
‹
fl
Control Panel
¤
‹
›
fi

Using the cancel button O
If you wish to interrupt the toasting process, press
the cancel button fi.
Using the frozen bread button
To toast frozen bread, do not adjust the browning
control, place the bread normally in the bread slots,
depress the bread carriage lever and press the frozen
bread button ›. The button will illuminate and the
toaster will automatically toast for an extended period.
Using the high lift release H
If small bread is toasted, this may be removed
more easily by raising the bread carriage lever to its
highest position.
Cleaning
1After use and before cleaning, switch off at the mains,
remove the plug and wait for the toaster to cool.
2Wipe the outside of the toaster with a damp cloth
only and dry with another cloth or tissue.
•NEVER use metal polish or coarse scouring agents
and never immerse your toaster in any sort of
liquid.
•NEVER use any pointed or sharp articles for
cleaning the inside, otherwise the heating element
will be damaged.
•NEVER use a brush or push your fingers or metal
objects down the slots.
Crumb tray
Crumbs will accumulate in the crumb tray and
could catch fire if not emptied periodically. When the
toaster has cooled down completely, tap the sides of
the case lightly to dislodge any crumbs lodged in the
toasting chamber and pull out the crumb tray ‡.
Empty the tray and replace it.
Additional points
•In order to achieve uniform browning, we
recommend you wait a minimum of 30 seconds
between each toasting, so that the control can
automatically be reset.
•If toasting one slice only, you may need to adjust
the browning control to a slightly lower setting.
•Stale bread toasts more rapidly than fresh bread.
Therefore, the browning control should be set at a
lower setting than usual.
•Because of the variable width bread slots feature, all
sorts of bread can be used as well as teacakes, small
rolls etc. Slices should not however be so thick as
to cause burning or jamming within the bread slots.
•When toasting multiple slices it is recommended
they are of equal size and freshness.
•Allow the toaster to cool fully before putting away.

6
Two year guarantee
This guarantee is valid in the UK and Ireland
only. It is in your interest to retain the retailers receipt as
proof of purchase. Please quote the following information
if the product develops a fault. These numbers can be
found on the base of the product.
Model No. Serial No.
All Morphy Richards Products are individually tested
before leaving the factory. In the unlikely event of any
appliance proving to be faulty within 28 days of purchase it
should be returned to the place of purchase for it to be
replaced.
If the fault develops after 28 days and within 24
months of original purchase, you should contact the
freephone number quoting Model number and Serial
number on the product, or write to the address below.
You will be asked to return the product (in secure,
adequate packaging) to the address below along with a
copy of proof of purchase. Subject to the exclusions set
out below (see ‘Exclusions’) the faulty appliance will then
be repaired or replaced and dispatched usually within 7
working days of receipt.
If for any reason this item is replaced during the 2 year
guarantee period, the guarantee on the new item will be
calculated from original purchase date. Therefore it is vital
to retain your original till receipt or invoice to indicate the
date of initial purchase.
To qualify for the 2 year guarantee the appliance must
have been used according to the manufacturers
instructions. For example kettles should have been
regularly descaled or an iron cord should have been
stored as recommended by the instructions.
EXCLUSIONS
Morphy Richards shall not be liable to replace or
repair the goods under the terms of the Guarantee where:
1 The fault has been caused or is attributable to
accidental use, mis-use, negligent use or used contrary
to the manufacturers recommendations or where the
fault has been caused by power surges or damage
caused in transit.
2 The appliance has been used on a voltage supply other
than that stamped on the products.
3 Repairs have been attempted by persons other than
our service staff (or authorised dealer).
4 Where the appliance has been used for hire purposes
or non-domestic use.
5 Morphy Richards are not liable to carry out any type of
servicing work, under the guarantee.
6 Plastic filters for all Morphy Richards kettles and coffee
makers are not covered by the guarantee.
This guarantee does not confer any rights other than
those expressly set out above and does not cover any
claims for consequential loss or damage. This guarantee is
offered as an additional benefit and does not affect your
statutory rights as a consumer.
Morphy Richards Limited, Mexborough,
South Yorkshire, England S64 8AJ
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design.
The Company, therefore, reserves the right to change the specification of its models at any time.
444-8304-87 Rev OI June ‘99