INSTALLATION INSTRUCTIONS
PAC0457
When using this lighting device
the safety precautions should be followed at all time
PLEASE READ CAREFULLY AND FOLLOW ALL
INSTRUCTIONS FOR YOUR OWN SAFETY
1. This device is designed for indoor use. Do not use outdoors.
2. Prior to installation, battery connector must be open to prevent high voltage
from being present on out put leads (red & yellow).
3. This product is for use with 14 W through 54W(2'-4')T5 and T8 single pin or bipin
for one lamp,Instant Start and Rapid Start,14W through 39W(2'-4')T5 and T8 single
pin or bipin for two lamp, Instant Start and Rapid Start,18 W through 50 W (4-pin)
long compact Rapid Start, or 32 W (4-pin) compact, 24Wthrough 32W U-Bend FBT8
fluorescent lamps from Philips,Osram and GE or equivalent manufacture.
4. Please ensure the electrical connections conform to the National Electrical
Code and local regulations if applicable.
5. To avoid electric shock, please disconnect normal and emergency power supplies,
and battery connector of the emergency ballast before servicing.
6. This device is designed for factory or field installation in either the ballast
channel, or on top of the indoor fixture, except air handling heated air outlets,
wet or hazardous location fixtures. Do not install this device near gas or
electric heaters.
7. AC power source of 120VAC or 277VAC is required.
8. The battery is sealed, non-maintenance, and is not replaceable in the field.
Please contact manufacturer for information on service. Do not attempt to
service the battery please.
9. Do not use accessory equipment that is not recommended by manufacturer.
Failure to do so may cause unsafe conditions. Servicing should only be
performed by qualified service personnel.
10. Do not use the product for other purpose that the product is NOT designed for.
PLEASE SAVE THESE INSTRUCTIONS
