MOSKO MOTO Backcountry 35L User manual

Backcountry 35L Pannier Kit Installation
1. Remove the wedge from the frame as shown in image below (bag not pictured for
clarity).
Tools Required:
- 4mm Hex Key
(included)

2. Mount the wedge to the pannier rack on the motorcycle as shown below using the
provided blue pucks (Qty 8), 40mm screws (Qty 16) and double hole washers (Qty 8)
pictured below.

3. Make sure the brackets are parallel to the wedge, uneven pressure may cause
damage.
4. Caution! Do not over tighten the mounting screws. Using a power drill may cause
damage, hand tighten only. Using the provided 4mm hex key, tighten the screws until
they are snug, then turn them another ½ turn. Check periodically for tightness.

5. Install the bag onto the wedge by sliding it on from above as shown. Note: if the locking
loop on the latch interferes with the grab handles or frame of the motorcycle the loop
can be removed with metal snips, angle grinder or a hacksaw.

6. Fasten the latch by rotating as shown. Be sure the latch engages with the keeper on
the wedge. Always check latches are secure before each ride.
Note: All fasteners on panniers are 2mm or 4mm hex head. These size hex keys are
provided for in the field re-torqueing or repair.