MOSKO MOTO Reckless 80 Revolver User manual

X 10
M6 Bolt
Washer
T-nut
Tool
Loctite
Step #1
Place T-nut on backside of center hole in main harness.
(This is easiest on a flat surface!)
Place bolt and washer in front side of leg harness center hole.
Hand tighten for now, keep loose.
M6 Bolt/washer
T-nut T-nut
M6 Bolt/washer
Step #3
Install remaining hardware in leg harness bolt holes and
corresponding main harness holes. (This is easiest on a flat surface)
Hand tighten only, until all hardware has been installed.
Finally tighten hardware using provided key.
Before riding, tighten all straps/bolts and check periodically.
Step #2
Place on motorcycle in desired location.
Revolve legs until they are at desired angle.
Note what lean angle the lean selector arrow is closest to.
Apply a small drop of included
Loctite to the bolts
Rotate, and loosely
attach leg straps
Reckless 80 Revolver
Assembly instructions
Right
Leg harness
Left
Leg harness
Main or Center
harness

Regularly check for tightness, wear, and loose straps.
Failure to do so may result in damage or injury. !
Reckless 80 Revolver
Installation instructions
4
1
2
3
5
Pass the rear mounting straps through
top tray slots or other available
sub-frame tubing at the back of bike
...now pass the leg straps through passenger
peg braces or other available frame location.
Begin to tighten and adjust all mounting straps equally
until desired position and tightness is achieved.
...return straps through holes and engage
with cam buckles, do not tighten yet
Finally, stow all mounting strap tails
using velcro loops
front of bike
(leg straps)
(rear straps)
(rear straps)

Heat Shield Placement
location that protects the bag and your motorcycle’s plastics from melting.
Dual exhausts, extra exposed or extremely hot running exhausts, may require a second heat shield.
Hose clamp
Heat Shield
It is important to check after each use that your heat shield is located properly.
Failure to do so may result in severe product/bike damage that is not covered
under warranty.