Motor Guard AF-4510 User manual

INSTRUCTIONS .
MODEL AF-4510
PARTICULATE FILTER
580 CARNEGIE STREET 1-800-227-2822
MANTECA, CA 95337 FAX [phone]
www.motorguard.com
Rev 01/18 33141
The AF-4510 Particulate Air Filter removes water, dust and debris from air lines, protecting air tools and system components from premature failure.
FEATURES
40 Micron Sintered Bronze Replaceable Element
Highly Visible, Ball-Float Type Sight Glass
Non-Clogging Manual Drain
SPECIFICATIONS
Maximum Airflow: 100 CFM
Operating Temperature Range: 40 -160 F
Maximum Inlet Pressure: 250 PSI
Port Size: 1/2 NPT
Before installing unit, relieve upstream pressure completely. Install unit level with drain facing down. Install unit in air supply line upstream of regulators
and lubricators. Unit should be installed as close as possible to the tools or appliances served. Install so that airflow is in the direction indicated by the
arrow on top of the unit. Unit is designed for installation in a 1/2" line. Use appropriate fittings for installation in other line sizes. Apply pipe thread
compound to male thread connections.
WARNING: This product is intended for use on industrial compressed air systems only. It is not to be used on life support or breathing air
systems. Do not install where pressures or temperatures can exceed those listed above.
Before pressurizing, be sure bowl is turned fully clockwise. Pressurize slowly to avoid high-pressure surge.
Inspect daily for leaks.
Check level of accumulated liquid daily at sight glass (2) and drain moisture by turning drain cock (1) counter-clockwise.
INSTALLATION .
OPERATION .

33141
Page 2
Filter Cleaning
Wash filter element regularly with kerosene to maintain filtration efficiency. To clean element, depressurize system, unscrew bowl and remove element
and baffle. Wash element and dry thoroughly before replacing. Wash sludge and sediment from bowl with warm soapy water. Inspect O-ring and
replace if damaged or distorted. Reassemble bowl, taking care not to damage threads. After bowl is tightened it may be rotated up to 180° for proper
viewing.
WARNING: Shut off air supply and drain residual pressure before attempting to service any part of the system!
Filter Replacement
Follow procedure outlined above for the replacement of the filter element.
Replacement Parts
MAINTENANCE .
Key
Part No.
Ord. No.
Description
Qty.
1
EL4026
74026
Element, Particulate, 40 Micron
1
2
RK4047
74047
O-Ring, Bowl, Std. Flow
1
3
EL4003
74003
Bowl Kit w/ Sight, Std. Flow
1
4
RK4204
74204
Sight Tube Kit, Std. Flow
1