In automatic or random
mode, use - and + to
select the group 1 or
group 2. Press for 3 seconds to enter the selected group. Use - and + to select channels. To set a
channel in the group, press once. To remove if from the group, press once. When the number
is flashing, it means that does not yet belong to the group. When the number is fixed, it belongs to
the group.
SET CURRENT DATE AND TIME PROGRAMMING TIMER
TRANSMISSION SIGNAL
CHOOSE CHANNEL / GROUP
1 • Press M until the
remote control is in
manual mode.
1 • Select the channel
you want using the
buttons - and .
Each time you press , the display will show in dynamic mode, indicating the signal
sending. The signal goes off when you stop pressing the button.
2 • Press for 3
seconds and the year
will flash.
2 • Press M until if
you put in automatic
mode (auto).
5 • Press to now set
the time and
use to change it.
NOTE • When you end the ascent and descent programming, the system automatically advances
to the next day. If you want to quit programming press for seconds.
6 • Press again to set
the minutes and
use to change
them.
3 • Use the - and to
scroll through the va-
rious values that defi-
ne the date / time and
the and keys to
change each value.
3 • Press for se-
conds. The Su will flash
and the zone of the
time will appear empty.
4 • In the end, press
the button to
confirm.
4 • Using , se-
lect the day you want
to program.
The display always shows what the channel functions.
When you press an order will be transmitted by the indicated channel at the bottom of
the display.
Will be defining the ascent.
Will be defining the descent.
• The V lithium battery (CR) should be replaced once a year to ensure the
correct operation of the transmitter;
• To replace the dead battery remove the plastic cover, remove the battery out and
insert the new one, respecting the polarity shown on the container;
• The used battery must be placed in containers intended for this purpose.
