Motorola Talkabout T62 User manual

Talkabout T62
OWNER’S MANUAL

de-DE
nO-N/
IL-),
da-DK
KX-+8
UX-58
en-US
it-IT
SW-37
XN-8$
es-ES
QE-12
VY-6(
fr-FR
pO-
P/
WU-
75

1
RF ENERGY EXPOSURE AND
PRODUCT SAFETY GUIDE FOR
PORTABLE TWO-WAY RADIOS
ATTENTION!
Before using this product, read the RF Energy Exposure
and Product Safety Guide that ships with the radio which
contains instructions for safe usage and RF energy
awareness and control for compliance with applicable
standards and regulation.
Package Contents
Package Content
T62
Radio
2
Belt clip
2
Battery
2
Power Supply
1
Stickersheet(16pcs)
1
Owner’s manual
1
Personalization Stickers:
Stickers are provided in order to personalize and keep
track of radios. Use permanent marker for the blank
stickers.
Frequency Chart
Ch. Freq. (MHz) Ch. Freq. (MHz) Ch. Freq. (MHz)
1 446.00625 7 446.08125 13
446.15625
2 446.01875 8 446.09375 14
446.16875
3 446.03125 9 446.10625 15
446.18125
4 446.04375 10 446.11875 16
446.19375
5 446.05625 11 446.13125
6 446.06875 12 446.14375
Note: *Only Channels 1 to 8 are available by default. Channels 9 to 16
need to be activated by user before they can be selected.
Channels 9 to 16 should only be used in countries where these
frequencies are allowed by government authorities.Channels 9 to
16 are not allowed in Russia.

2
Features and Specifications
•8 PMR Channels. User expandable to 16 Channels in
countries where allowed by government authorities.
•121 Sub-Codes (38 CTCSS Codes & 83 DCS codes)
•Up to 8 km Range*
•iVOX/VOX
•Easy Pairing
•20 Selectable Call Tone Alerts
•Backlit LCD Display
•Roger Tone
•Micro USB Connector for charging
•Battery Level Meter
•Channel Monitor
•Channel Scan
•Dual Channel Monitor
•Keypad Lock
•Auto Squelch Control
•Auto Repeat (Scrolling)
•Battery Low Alert
•Keypad Tone (On/Off)
•Power Source: NiMH battery Pack/3 x AA Alkaline
batteries
•Battery Life: 16 Hours (under typical use conditions)
Note: *Range may vary depending on environmental and/or
topographical conditions.
Radio Control Buttons and Display

3
Stickers
1. Channel [1–8/* 1–16]
2. Call Tone [Off, 1–20]
3. Roger Tone [On/Off]
4. Dual Channel Monitor
5. Keypad Tone [On/Off]
6. Easy Pairing
7. Speaker Volume [0–7]
8. Battery Indicator [3 Battery Levels]
9. Status
[Transmit]
10. Status [Receive]
11. Scan Indicator
12. Keypad Lock
13. iVOX [Off, L1,
L2, L3] VOX
[Off, L1, L2, L3]
14. Sub-Code [0–
121]
Note: *Only Channels 1 to 8 are available by default.
Channels 9 to 16 need to be activated by user
before they can be selected.
Channels 9 to 16 should only be used in countries
where these frequencies are allowed by government
authorities.
Channels 9 to 16 are not allowed in Russia.
2
3
4
5
1
6
7
8
9
11
13
10
12
14

4
Installing the Batteries
Each radio can either use a NiMH rechargeable
battery pack or three units of AAAlkaline Battery,
and beeps when the batteries are low.
1. Make sure your radio is turned off.
2. To remove the battery compartment door,
press the tab atthe bottom of the compartment
door.
3. For NiMH battery pack, insert the battery
pack with the and signs facing you. Observe
polarity. For AA Alkaline batteries, insert the
batteries. Observe polarity.
4. Close the battery compartment door.
Radio Battery Meter
The number of bars (0–3) on the Radio Battery icon
shown indicates the charge remaining in the battery.
When the radio battery meter shows one segment left,
the radio chirps periodically or after releasing the PTT
button (Low Battery Alert).
Battery Capacity Maintenance
1. Charge the NiMH batteries once every three
months when not in use.
2. For storage purposes, remove the battery
from the radio.
3. Store the NiMH batteries in a temperature
between -20 °C to 35 °C and in low humidity.
Avoid damp conditions and corrosive
materials.
Using the Micro-USB Charger
The micro-USB charger allows you to charge
your NiMH battery pack.
1. Power off your radio before start charging.
2. Plug the micro-USB cable into the micro-USB
chargingport on your radio.
3. Connect the USB charger to a nearby and easily
accessible wall power outlet.
4. An empty battery will be fully charged in 8 hours.
5. The battery meter bar will scroll when the battery is
charging.
Note: When moving between hot and cold temperatures, do not
charge the NiMH battery pack until the temperature
acclimates (usually about 20 minutes).
For optimal battery life, remove the radio from the charger
within 16 hours. Do not store the radio while connected to
the charger.
Turning your Radio On and Off
Press and hold the Power button to turn the radio on or
off.
1. In the on position, the radio chirps and
briefly shows all feature icons available on the radio.

5
2. The display screen then shows the
current channel, code, and all features that are
enabled.
Setting the Volume
From Standby Mode, press on either or
to show the current value. Press or
again to adjust the volume setting.
1. Press to increase the speaker volume.
2. Press to decrease the speaker volume.
Do not hold the radio close to your ear. If the
volume is set to an uncomfortable level, it could
hurt your ear. Adjust ‘0’ to mute the speaker.
Talking and Listening
All radios in your group must be set to the same
channel and Sub-Code in order to communicate.
1. Hold your radio 2–3 cm from your mouth.
2. Press and hold the PTT button while speaking. The Transmit icon appears on the display.
3. Release the PTT button. You can now receive incoming calls. When you do, the Receive icon appears on the
display.
For maximum clarity, hold the radio 2 to 3 cm away and avoid covering the microphone while talking.
Talk Range
Your radio is designed to maximize performance and improve transmission range. Ensure the radios are at least 5
feet apart when in used.
Monitor Button
Pressing and holding Scan/Monitor for 3 seconds to enter Monitor mode and listen for weak signals on the current
channel. You can also listen to the volume level of the radio

6
when you are not receiving. This allows you to adjust the Menu Key volume, if necessary.
Menu Key
Menu Key
Menu Key
Menu Key
Menu Key
Menu Key
Menu Key
Two Way Mode
Channel (1-8 / *1-16)
Sub-Code (0-121)
Call Tone (Off, 1-20)
Keypad Tones (On/Off)
Dual Channel Monitor Channel (1-8 / *1-16)
Dual Channel Monitor Sub-Code (0-121)
Internal Voice Operated Transmission/
Voice Operated Transmission
(
iVOX,VOX) (Off, L1,L2,L3)