MoTrike M-010 User manual

Recumbent Trike Assembly Instruction
M-010 And M-010F
www.zzmerck.com Page 1/15

Check all the parts
Main frame (cross frame)
Main frame (rear fork)
Front boom with crankset
Handlebars
Front wheels with steering shaft
www.zzmerck.com Page 2/15

Rear wheel
Steering rod
Brake and derailleur cables
Chain tubes
Seat
www.zzmerck.com Page 3/15

Rear derailleur, pedals, chain
Bolts and screws
Mirrors
Tools
www.zzmerck.com Page 4/15

1. Assemble the main frame
a. Connect the cross frame and reak fork by the bolts b. Tighten the quick released screw
c. Finish assembly the main frame
www.zzmerck.com Page 5/15

2. Assemble the rear wheel
a. Put the rear fork and rear wheel in right position b. Tighten the quick released screw
3. Assemble the front wheels
a. Take off the head sets from the steering shaft
b. Insert the steering shaft into the cross frame.
(Please pay attention to the position of the parts ①②③④.)
www.zzmerck.com Page 6/15

4. Assemble the steering rod
Mount the steering rod on the steering shaft
(Please do not adjust the length of the rod.)
5. Assemble the handlebars
a. Insert the handlebars into the steering shafts and tighten the screws
b. Mount the head cover
www.zzmerck.com Page 7/15

6. Assemble the handlebars
Insert the front boom into the tube of cross frame.
(The distance in the tube shoul be at less 15 cm for security.)
7. Assemble the rear derailleur
Assemble the rear derailleur on the rear fork
www.zzmerck.com Page 8/15

8. Assemble the chain tube
a. Insert the chain tubes into the ring
b. Fixed them by screw
c. Finish assembly the chain tubes
www.zzmerck.com Page 9/15

9. Assemble the chain
a. Pass the chain through the short chain tube, chain wheel, cassette, rear derailleur, long chain
tube, crankset, and then connect the chain.
(Chip "L" pin through the end of the chian.)
www.zzmerck.com Page 10/15

The structure of chain
www.zzmerck.com Page 11/15

10. Assemble the brake cables
a. Remove the outer casing and b. Thread the inner wire through brake lever
put the inner wire into brake lever tighten the screw and insert it to outer casing
c. Thread the inner wire through the hole on the caliper d. Tighten the screw
www.zzmerck.com Page 12/15

11. Assemble the front derailleur cable
www.zzmerck.com Page 13/15
Thread the front derailleur cable outer casing through the guide on the side of the frame and up towards the
end of the front boom. Thread the inner wire through the outer casing and then through the cable guide tube.

12. Assemble the rear derailleur cable
13. Assemble the seat
www.zzmerck.com Page 14/15
Thread the rear derailleur cable outer casing through the guide on the side of the frame and up towards the
end of the front boom. Thread the inner wire through the outer casing and then through the cable guide tube.

14. Assemble the pedal and mirror
Pay the attention to Left and Right pedal Mount the mirros in the top of the handlebars
15. Mount the flagpole and put the end of cables in the production cover
16. Finish the assembly
www.zzmerck.com Page 15/15