Moza RS31 User manual

MOZA
Hand Brake
01 Product Introduction
Aviation-grade Aluminum
Easy to Fix
Two Modes
16-bit High Precision Angle Sensor
Adjustable Height & Angle
Adaptable Brake Force & Travel
Direct connection to PC via MOZA Universal Hub
02 Lever Height & Angle Adjustment
Unscrew the nuts with two open-end wrenches counterclockwise, adjust the lever's
height and angle, and then tighten the screws. (It’s recommended to apply the flat and
spring pads supplied in the tool kit to avoid scratches.)
03 Spring Replacement
1) Remove the cover above the spring with a Phillips screwdriver
2) Remove the baffles on both sides with an Allen wrench
3) Pull the handbrake lever until the spring and the baffles tilt
4) Remove the screws with a flat-head screwdriver and install the spring
5) Adjust the baffle, put the cover back in place, and tighten all screws

04 Configuration in MOZA Pit House
1) Set the start and end points to adjust handbrake travel and eliminate the
dead zone.
2) Adjust the output curve to change the correlation between mechanical travel
and signal output at the initial and final stages.
3) Click the calibration button and follow the instructions to re-calibrate if you
experience any handbrake output abnormalities.
4) Two mode options: on/off button mode or axis mode with continuous brake
travel.
05 Package Content
Handbrake base
Handbrake lever
1 * Philips screwdriver
1 * Flathead screwdriver
1 * Spring (blue color)
2 * Hex screws
2 * data cables (USB-b, RJ45)
2 * hex screws (come with flat pads, spring pads, and nuts)
2 * umbrella head screws (come with flat pads)
3* Allen wrenches
Product Parameters
Material: Aluminum
Dimension: 153* 68.3* 365.5mm
Adjustable resistance: supported
Horizontal lever mount: supported
Side-mount: optional
Bolt pattern: M6X14
Net weight: 0.7 KG