Muskoka Sanford MEF253OK User manual

ELECTRIC FIREPLACE MANTEL Crafted in a Traditional Style
MANTEAU DE CHEMINÉE ÉLECTRIQUE Confectionné en style traditionnel
REPISA DE CHIMENEA ELÉCTRICA Fabricado con diseño tradicional
REV01
111
YEAR
ANN E
A!O
I
N
H
O
M
E
W
A
R
R
A
N
T
Y
G
A
R
A
N
T
I
E
"
L
A
M
A
I
S
O
N
G
A
R
A
N
T
#
A
E
N
S
U
P
R
O
P
I
A
C
A
S
A
Assembly Instructions
Instructions d'assemblage
Instrucciones de montaje
MM253OK

TIPS FOR THE ASSEMBLY OF
YOUR NEW MANTEL
• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.
• A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will take approximately
30-60 minutes.
BASE 1PC
ZZ.253OK.01
LEFT FRONT
PANEL 1PC
ZZ.253OK.03
LEFT SIDE PANEL
1PC
ZZ.253OK.04 RIGHT FRONT
PANEL 1PC
ZZ.253OK.05
RIGHTSIDE
PANEL 1PC
ZZ.253OK.06
UPPER FACING
PANEL 1PC
ZZ.253OK.07
CENTRAL PANEL
1PC
ZZ.253OK.08
ANTI-TIP DEVICE 2 SETSFLAT HEAD SCREWS
2PCS 2PCS 4PCS 4PCS
29PCS 4PCS 4PCS
INSIDE
VIEW
OUTSIDE
VIEW
1
TOP 1PC
ZZ.253OK.02

GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is RED and located inside the packaging, taped to the top box. Be sure you DO
NOT discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the base, take the left side panel, positioning it so the holes
in the blocks on the bottom line up with the holes on the base. Position the left
front panel next to the left side panel, lining up the holes in the blocks with the
holes on the base. Attach the left front and side panel to the base by inserting
and tightening 1 screw to each piece. Attach the left side and left front panels
together by inserting and tightening
3 screws.
Step 3
Repeat Step 2, but with the right side panel and the right front panel.
2

Step 4
Locate the central panel and position it by resting the panel on the
front legs of the left and right front panels. Make sure the holes are
lined up, then insert and tighten 1 screw on each side.
Step 5
Locate the upper facing panel that will be attached to the left
and right legs and will sit above the firebox behind the central
panel. Position this panel with the finished oak side facing the front
of the mantel. Line up the holes on each side and insert and tighten
2 screws on each side.
Step 6
Get your assistant and locate the top of your mantel. This top is very heavy. It will take 2 people to lift
and position it in place. Ensure the top goes over the positioning guide located on the header. The top
must go over this guide to be positioned correctly.
3
INSIDE
VIEW
OUTSIDE
VIEW

Step 7
Take your electric firebox out of its packaging and position it
between the 2 legs of the mantel. Once you are close to the wall,
plug the firebox into the nearest outlet.
The firebox comes with 3 metal brackets and 20 black screws. These
metal brackets must be attached to both the sides of the firebox and
the mantel to ensure that your firebox does not move around as you
use it. 2 of the brackets have 2 large holes on one side. These large
holes line up with the 2 screws on the side of the firebox. The other
screws provided must be inserted into the holes at the other end of the
bracket and into the firebox. The other side of each bracket attaches
to the mantel.
The 3rd bracket has no holes on 1 side. That side should go up against
the firebox top but should not be attached as the heater sits right
underneath the bracket. Only the mantel side should be attached.
If you have any questions about the firebox please reference the
installation instructions that come with the firebox. Please reference
the Quick Tips section of that instruction manual.
Step 8
You are now ready to position your mantel against the wall.
This step requires 2 people to move the unit.
Anti-tipping device
At this point you must attach the anti-tipping device to your mantel
and your wall. This device is a safety feature that will prevent your
mantel from tipping over if a weight is applied which can unbalance
the unit.
4

WARRANTY
Greenway Home Products is pleased to offer in-home warranty repairs. Please refer to your
Firebox Use and Care Guide for warranty information on your Firebox.
DO NOT RETURN THIS PRODUCT TO THE STORE:
Please contact Customer Service at: 1-866-253-0447
Monday to Thursday from 8:30AM to 5:00PM (EST), Friday from 8:30AM to 4:00PM (EST)
Web: www.greenwayhp.com
Email: suppor[email protected]
Canada: 400 Southgate Dr., Guelph, Ontario, Canada, N1G 4P5
USA: 6507 Fairfield Dr., Northwood,Ohio, USA, 43619
Limited Warranty Definitions:
Greenway Home Products:
(Greenway) Manufacturer.
Mantel: Mantel manufactured by Greenway Home Products.
Purchaser: Purchaser of the Mantel
Distributor: Facility authorized to sell Greenway Home Products.
Warranty Card Greenway Home Products Limited Warranty Registration
Card identifying the Purchaser and product model.
Greenway Limited Warranty:
Greenway warrants to the Purchaser that the Mantel is free from defects in material and
workmanship, under normal use and service, for 1 year (1 year limited parts) from the date
of purchase.
All warranty repairs must be preauthorized by Greenway Home Products. Greenway will,
at its’ option, replace or repair free of charge any defective part, which the Purchaser shall
notify their Distributor or Greenway Home Products within the warranty period. The
obligation of Greenway Home Products under this warranty, is expressly limited to such
replacement or repairs.
The provisions of this limited warranty shall not apply to the following:
1. Accidents.
2. Unauthorized repairs or alterations.
3. Normal maintenance.
4. Changes made to other units manufactured after this mantel was manufactured.
5. Incidental damages caused by failure of the mantel such as inconvenience or loss of use.
6. Improper installation.
The provisions of this limited warranty shall not apply to deterioration due to wear and
exposure beyond the following limitations:
1. For 180 days from the date of purchase for exterior finished surfaces.
5

Due to the properties of natural wood, Greenway Home Products makes no warranty against
mineraling of wood components.
Greenway Limited Warranty is void unless the following conditions are adhered to:
1. Warranty registration must be completed and returned to a Greenway Home Products.
2. All warranty repairs must be preauthorized by a Greenway repair facility.
3. Greenway reserves the right to inspect defective parts that have been replaced under
warranty. Dealer is expected to hold defective parts for 60 days.
4. Only parts and accessories and other material, available through Greenway Home
Products are to be used in the performance of warranty service.
5. Purchasers are responsible for presenting/notifying their Distributor as soon a problem
exists. The warranty repairs should be completed in a reasonable amount of time from
the date of authorization. Not to exceed 30 days past notification.
This limited warranty is expressly in lieu of any other expressed or implied warranty,
including any implied warranty or merchantability or fitness for a particular purpose and of
any obligations or liabilities on Greenway Home Products which neither assumes nor
authorizes any other person to assume for it any other liability in connection with the Mantel
manufactured by it.
The warranty is null and void if used in commercial or industrial applications.
6