Empire Comfort Systems LS50TINF User manual

Page 1
GAS-FIRED
INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
WARNING
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
— Do not store or use gasoline or other
ammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
• If you cannot reach your gas
supplier, call the re department.
— Installation and service must be
performed by a qualied installer,
service agency or the gas supplier.
LOG SET MODEL
LS50TINF
For Use With
DVCT50 Fireplaces
�
WARNING
If not installed, operated and maintained
in accordance with the manufacturer’s
instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
NOTICE: Ceramic logs may differ in appearance
from those shown in this manual.
INSTALLATION INSTRUCTIONS
(SEE HOMEOWNER MANUAL FOR OPERATING INSTRUCTIONS)

39982-0-1118Page 2
LOG IDENTIFICATION
DVCT50
PART# FRONT TOP
40355
Log (A) Log (A)
40356
Log (B) Log (B)
40357
Log (C) Log (C)
40358
Log (D) Log (D)
40359
Log (E) Log (E)
40360
Log (F) Log (F)
40361
Log (G) Log (G)
40362
Log (H) Log (H)
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.

39982-0-1118 Page 3
LOG IDENTIFICATION
DVCT50
PART# FRONT TOP
40363
Log (I) Log (I)
40364
Log (J) Log (J)
40365
Log (K) Log (K)
40366
Log (L) Log (L)
40367
Log (M) Log (M)
40368
Log (N) Log (N)
40369
Log (O) Log (O)
40370
Log (P) Log (P)
40371
Log (Q) Log (Q)
USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Attention: When ordering parts, it is very important that part number and description of part coincide.

39982-0-1118Page 4
NOTE: Install liners before logs. See separate Liner Installation
manual for details.
CAUTION
Do not handle these logs with your bare hands. Always
wear gloves to prevent skin irritation from ceramic bers.
After handling the logs, wash your hands gently with soap
and water to remove any trace of bers.
Accessing the Interior of the Fireplace
See Homeowners Manual for instruction on how to remove the
barrier screen and glass door.
Log Set Installation
The positioning of the logs is critical to the safe and clean
operation of this replace. Sooting and other problems may result
if the logs are not properly and rmly positioned in the replace.
Please refer to (Figure 1) and the following WARNING when
completing log placement instructions. For step by step log
placement instructions, (See Pages 5 - 21).
WARNING
Failure to position the parts in accordance with this diagram
or failure to use only parts specically approved with this
replace may result in property damage or personal injury.
A
B
C
DE
F
G
H
I
J
K
LM
N
O
P
Q
Figure 1
Burner Pin Location
Figure 2
Glowing Embers Information
1. Carefully separate the ember material into small amounts
(no larger than “dime-size” pieces).
a. Fluffed up pieces of ember material one layer thick
will produce the best ember glow. Do not place more
than one layer of ember material onto the burner.
Excess ember material will decrease the ember
glow effect.
b. Save any remaining ember material for future
applications (as needed).
Figure 3
LOG AND EMBER PLACEMENT
Video of log installation available on our website at:
www.empirecomfort. com.

39982-0-1118 Page 5
LOG AND EMBER PLACEMENT
1. Place large charred Ember Bed (A) onto burner base and front and rear ember bed center burner tubes.
TOP
FRONT

39982-0-1118Page 6
LOG PLACEMENT
2. Place Ember Piece (B) on left rear of the burner base and onto Pins 2 and 3 on left rear.
TOP
FRONT

39982-0-1118 Page 7
LOG PLACEMENT
3. Place Ember Piece (C) on right rear of the burner base and onto Pins 4 and 5 on right rear.
TOP
FRONT

39982-0-1118Page 8
LOG PLACEMENT
4. Place Ember Piece (D) on left front of burner base and onto Pin 1 on left front.
TOP
FRONT

39982-0-1118 Page 9
LOG PLACEMENT
5. Place Ember Piece (E) on right front of burner base and onto Pin 6 on right front.
TOP
FRONT

39982-0-1118Page 10
LOG PLACEMENT
6. Place Log (F) onto Ember Bed (A) Pins 1 and 2 located on left side and left front.
TOP
FRONT

39982-0-1118 Page 11
LOG PLACEMENT
7. Place Log (G) onto burner base Pins 3 and 4 located on right side and right center.
TOP
FRONT

39982-0-1118Page 12
LOG PLACEMENT
8. Place Log (H) onto two pins of Ember Piece (C) on rear center.
TOP
FRONT

39982-0-1118 Page 13
LOG PLACEMENT
9. Place decorative rocks across burner base in front of the burner tube. Do not cover the burner tube ports.
TOP
FRONT

39982-0-1118Page 14
LOG PLACEMENT
10 Place the Glowing Embers on the burner tubes covering all ports. Place embers on Ember Bed (A) as shown.
TOP
FRONT

39982-0-1118 Page 15
LOG PLACEMENT
11. You may press some embers onto the front side of Logs G and H to help create glow when the re is burning.
TOP
FRONT

39982-0-1118Page 16
LOG PLACEMENT
12. Place Log (I) onto front bottom right liner in front of front burner tube on front right.
TOP
FRONT

39982-0-1118 Page 17
LOG PLACEMENT
13. Place Log (J) onto front bottom center liner in front of front burner tube on front center.
TOP
FRONT

39982-0-1118Page 18
LOG PLACEMENT
14. Place Log (K) onto orice air box located on far right.
TOP
FRONT

39982-0-1118 Page 19
LOG PLACEMENT
15. Place Log (L) onto left pin of Log (F) and onto Ember Piece (B) on left top.
TOP
FRONT

39982-0-1118Page 20
LOG PLACEMENT
16. Place Log (M) onto pin on Log (G), located on right of Log (G) and right chunk.
TOP
FRONT