mxr Dyna Comp Bass Compressor User manual

M282 | Dyna Comp© Bass Compressor 2
1OUTPUT knob adjusts volume of compressed signal
2CLEAN knob adjusts wet/dry signal mix added to the compressor’s output
3SENSITIVITY knob adjusts sustain time
4ATTACK switch toggles between slow & fast attack times
5TONE knob cuts/boosts midrange at 1kHz
6FOOTSWITCH toggles effect on/bypass (blue LED indicates on)
1
2
5
4
3
6
External Controls

M282 | Dyna Comp© Bass Compressor 3
Basic Operation
1 Run a cable from your guitar to the M282’s INPUT jack and run
another cable from the M282’s OUTPUT jack to your amplifier.
2 Start with all knobs set to 12 o’clock.
3 Turn the effect on by depressing the footswitch.
4 Rotate CLEAN knob to increase amount of unaffected signal to be
added to compressor’s output or counterclockwise to decrease it.
5 Rotate SENSITIVITY knob clockwise to increase sustain time or
counterclockwise to decrease it.
6 Push ATTACK switch to toggle between default slow attack time
and fast attack time, indicated by red LED.
7 Rotate OUTPUT knob clockwise to increase effect volume or
counterclockwise to decrease it.
8 Rotate TONE knob clockwise to boost midrange at 1kHz or
counterclockwise to cut it.
The Dyna Comp®Bass Compressor is powered by one
9-volt battery (remove bottom plate to install), the Dunlop
ECB003 9-volt adapter, or the DC Brick™, Iso-Brick™, and
Mini Iso-Brick™ power supplies.
Power
Directions

M282 | Dyna Comp© Bass Compressor 4
Specifications
Input Impedance 600 kΩ
Output Impedance 25 kΩ
Max Input Level -5 dBV
Max Output Level +2 dBV
Max Compression 36 dB
THD* 0.2%
Noise Floor** -100 dBV
Current Draw 11 ma
Tone +/- 7dB, 1kHZ
Power Supply 9 VDC
* Measurements made at -dBV, 1kHZ
** A-weighted, all controls mid position