NAD 7600 User manual

7600 Stereo Receiver
Date of manufacture : Jan 87 - Jun 90
Please note that this document contains the text from the original product brochure, and some technical statements may now be out of date
The NAD 7600 is one of the world’s most powerful, most sensitive, and most flexible stereo receivers. It
consists of NAD’s three finest Monitor Series stereo separates 11300 Preamplifier, 4300 Tuner, and
2600A Power Amplifier), combined on a single chassis and operated by infrared remote control.
The 7600 is rated at 150 watts/channel for continuous test tones, but its Power Envelope circuitry
produces much higher levels of tone-burst power for music. Even with compressed recordings of rock
music in which the peaks are only a few dB higher than the aver-age power, the 7600 maintains a
clipping level above 500 watts per channel into the complex 4-ohm impedance that is typical of real
loudspeakers. In bridged mode a 7600 matched with a 2600A will deliver nearly 3000 watts of dynamic
power into a pair of such speakers. The FET-input MM phono stage, employing eight selected low-noise
transistors per channel, combines superb sound-stage imaging and detail with superior rejection of
digital and radio-frequency interference. A separate class-A pre-preamplifier furnishes exquisitely quiet,
wide-range moving-coil playback. The line-level circuits in the 7600, including its feedback-operated
volume control, have a 118dB signal/noise ratio that preserves all the delicacy and purity of low-level
musical information. Bass EQ and semi-parametric tone controls provide flexible sonic tailoring to
compensate for differences in recordings, speakers, and listening rooms.
The tuner section of the 7600 shares the unique ultra-sensitive front end of the 4300. Together with
NAD’s FM NR noise-reduction system, it provides exceptionally clear and quiet reception of weak signals.
Whether you use the convenient rotary knob, the 16 presets, or the remote control for tuning, you are
assured of crystal-controlled digital accuracy.
Combining convenience with superbly musical performance, the NAD 7600 is a no-holds-barred product
that establishes new standards in receiver design.

PRE-AMP SECTION
Phono input
Input impedance (R and C) MM 47kΩ/ 120pF
MC 47kΩ/ 120pF
Input sensitivity, 1kHz MM 0.28mV ref. 1W
MC 0.02mV ref. 1W
Signal/Noise ratio (A-weighted with cartridge connected) MM 76dB ref. 5mV
MC 76dB ref. 5mV
THD (20Hz - 20kHz) <0.04%
RIAA response accuracy (20Hz - 20kHz) ±0.5dB
Line level inputs
Input impedance (R and C) 50kΩ/ 250pF
Input sensitivity (ref. 1W) 15mV
Maximum input signal >10V
Signal/Noise ratio (A-weighted ref 1W) 96dB
Frequency response (20Hz - 20kHz) ±0.3dB
Line level outputs
Output impedance Pre-amp 600Ω
Tape Source Z + 1kΩ
Maximum output level >10V
Tone controls
Treble ±12dB at 3, 6 or 12kHz
Bass ±12dB at 50, 120 or 250Hz
Bass EQ +3dB at 60Hz
+6dB at 36Hz
Infrasonic filter (Switchable) -3dB at 14Hz, 12dB / octave
POWER AMP SECTION
Continuous output power into 8Ω* 150W (21.7dBW)
Rated distortion (THD 20Hz - 20kHz) 0.03%
Clipping power (maximum continuous power per channel) 170W
IHF Dynamic headroom at 8Ω+4dB
IHF dynamic power (maximum short term power per channel) 8Ω400W (26dBW)
4Ω600W (28dBW)
2Ω800W (29dBW)
Damping factor (ref. 8Ω, 50Hz) >120
Input impedance 30kΩ/ 1500pF
Input sensitivity (for rated power into 8Ω)1V
Frequency response 3Hz - 80kHz +0, -3dB
Signal/noise ratio ref. 1W 100dB
ref. rated power 122dB
THD (20Hz - 20kHz) <0.03%
Bridged Mode
Continuous output power into 8Ω* 400W (26dBW)
IHF Dynamic headroom at 8Ω+5dB
IHF dynamic power (maximum short term power per channel) 8Ω1.2kW (31dBW)
4Ω1.4kW (31.5dBW)
© NAD Electronics. All rights reserved. E & OE

FM TUNER SECTION
Input sensitivity Mono -30dB THD+N 9dBf (0.8µV/75Ω)
Mono 50dB S/N 12dBf (1.1µV/75Ω)
Stereo 50dB S/N 24dBf (4.5µV/75Ω)
Stereo 60dB S/N 35dBf (15µV/75Ω)
Capture ratio (45 - 65dBf) <1.5dB
AM rejection (45 - 65dBf) >70dB
Selectivity, alternate channel 80dB
Selectivity, adjacent channel 10dB
Image rejection >120dB
I F rejection >100dB
Harmonic distortion Mono 0.07%
Stereo 0.07%
Signal/Noise ratio Mono 85dB
Stereo 80dB
Frequency response ±0.5dB 30Hz - 15kHz
Channel separation at 1kHz 55dB
AM TUNER SECTION
Usable sensitivity 200µV
Selectivity 55dB
Image rejection 50dB
I F rejection 35dB
Signal/Noise ratio 45dB
Harmonic distortion 0.5%
Remote Yes
NAD Link No
PHYSICAL SPECIFICATIONS
Dimensions (W x H x D) 435 x 162 x 422mm
Net weight 15.4kg
Shipping weight 16.3kg
Power consumption (120 ~ 240V, 50/60Hz) 700VA
* Minimum power per chnnel, 20Hz - 20kHz, both channels driven with no more than rated distiortion.
Dimensions are of unit’s cabinet without attached feet; add up to 18mm for total height.
Dimension depth excludes terminals, sockets, controls and buttons.
© NAD Electronics. All rights reserved. E & OE