National Office Furniture 2513735 User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
RecommendTools
• Drill
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2513735
Rev, -
Printed in U.S.A
© 2013 Kimball International, Inc.
Epicenter Full Height
Inserts—Veneer/
Laminate
1 After all ganging is complete and Epicenters have been installed,
align the mounting brackets on the back of the Full Height insert with
the upper Epicenter U-channel and lower Epicenter U-channel
(Figures A & B).
Figure A
Figure B
Package Contents Qty.
•Insert 1
•Brackets 1
•1/16” Diam. Washer Per Order
•#6 x ¾” Screws 4
•#8 x ½” Screws Per Order

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2513735
Rev, -
Printed in U.S.A
© 2013 Kimball International, Inc.
Epicenter Full Height
Inserts
2 Push Inserts toward center of run in all ganging applications. If gap is
present on end of runs, install blinders onto end of end of run inserts
(Figure C). Reference AI2508094 to install blinders.
Figure C
3 If Panels are out of plane with each other (Figure D), use additional
brackets to bring into same plane (Figure E).
Figure D
Potential Blinder Location Potential Blinder Location

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2513735
Rev, -
Printed in U.S.A
© 2013 Kimball International, Inc.
Epicenter Full Height
Inserts
• Laminate and veneer inserts will require drilling (4) 6 x ¾” Panhead
philips screws to attach the brackets between inserts.
Figure E (Back View)
a If inserts show any bowing, use drill with 8 x ½” screws and (2 to 1)
1/16” outside diameter washers to pull out bow (Figure F).
Figure F (Bowing Examples)

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2513735
Rev, -
Printed in U.S.A
© 2013 Kimball International, Inc.
Epicenter Full Height
Inserts
b Drill screws with 1 to 2 washers through Epicenter frame slot as necessary.
Drill will go through U-channel slot to secure fastener to insert. Use as
many as necessary to pull out bow in wood/laminate inserts (Figure G1 and
G2). Bow may also be pulled out using screws through the back of the lower
epicenter L (see Figure G3).
Figure G1 (Upper Epicenter with bowing inserts) Figure G2 (Drilling assembly)
Figure G3 (Screwing into back of Lower Epicenter L)
Lower Epicenter L