Nauticam 16120 User manual

InstructionManualforNauticam RaptorHousing

What’sinthepackage?
Page1

What’sinthepackage?
Page2

ChapterI,Installthecamera
•TurntheLockLevershowninyellowCCW torelease,thentakeoutthecameratray.
•MountingthecameratraytoRaptortopwiththeAllenkeydelivered.

•MicroV‐mountbatterycanbeinstalledorlater.
•MountingthebottomtraytoRaptor,thenfastenitbytwoscrews.

‐Mountingtherightcontrolblocktocamera,fastenitwiththe3thumbscrews

•InstallRFmountlenstocamera,and
LocktheRFmountLockingring.
•ForusewithEFlens,CanonEF–
EOSRMountadapterisrequired.

•InstalltheEFRELBlockforusewithEFlensandEF–RFMountadapter,
Fastenitwithtwothumbscrews.
EFlensuseonly.

•AsforusewithControlRing/V‐NDmountadapter,pleaseadjustthe
controldialpositionasshownabove.
EFlensuseonly.

•TurndownthetwoLock
leverstoreleaselens
controlunit.
•Installthewholecamera
systemtohousing
•Turnup theLockleversto
engagethezoomandfocus
gear.

•PullouttheLEMOconnectorinsidehousing(lowerleft).
•PlugitintocameraEXTport.

ChapterII,PreparationforElectricalcontrols
UpdateRaptorcameratothelatestfirmware(BETA).
Enablesthe5V/500mApowerouttotheExtensionPortbysetting
Menu/SystemSettingMenu/Power/Powerout/Enable
EnableAFbysettingMenu/Autofocus‐BETAMenu/Enable
Remarks
Backlight‐ LongpressPREbuttontoturniton,turnoffbyholdingtheWB.
FPS+/‐ ‐ NOTsupportedyet,waitingforthefirmwareupdatebyRED.
Gentlypushthesebuttonstoprotecttheinternalelectroniccomponents.