Nauticam 36183 User manual

Please
follow the instructions below to
mount the
dedicated 4.33" dome
p
ort
on
the
NA
-
EOSM
housin .
1.
Detach
A from the port
by turnin
it
anti
-
clockwise while holdin B firmly.
2.
Install the camera body only into the housin
.
*Please refer to the housing manual for installing
camera into the housing.
3.
Ali n the port mountin indices of
B
and the
housin . Gently push B into the port openin of
the housin , until it cannot o in any further.
*Please refer to housin manual for lockin
and un-lockin the port.
B
A

5.
Remove the O
-
rin from
A
, inspect for any
dama e and li htly coat it with the provided
lubricant. Clean the O-rin roove before
placin it back.
6. Verify that the threaded section of B and
sealin surface are clean and free from forei n
material.
7. Ali n the external threaded section of A and
the internal threaded section of B.
4.
M
ake sure the
zoom
k
nob is at its most
outwards position before mountin / un-
mountin the lens. The knob should be left at
this position until it is made sure that the lens
and zoom ear is properly installed.
8.
Attach
A
on
B
by holdin the housin firmly and
turnin A clockwise until it cannot o in any
further.
9. En a e the ear by pushin in the knob, then
turn the knob both ways to check if the lens
zoom in and out.
10. To un-mount the port, reverse the above steps.
A