Nauticam 36183 User manual

Instruction Manual for 4.33" dome port for
Canon EF-EOS M adaptor and EF 8-15mm
f 4L Fisheye USM
PN# 36183
F OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, e pride ourselves in the ability to recognise the requirements
of professional as ell as amateur under ater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allo ing stress-free installation and easy
operation of all important functions of the camera.
Each product is individually inspected and ater pressure tested to ensure
optimum quality.
Please read this manual carefully before using the product, this ill maximise
its performance as ell as its lifetime.
W ARRANTY
All NAUTICAM Products are arranted against any material and
manufacturing defects for t o years from the date of purchase for consumer
use. This arranty only applies to products purchased from authorised
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service centre(s). Please note that this arranty only applies hen the
product is purchased in the territory here the service centre is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used ith and/or placed ithin our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthorised modifications and/or repairs of our products ill automatically
invalidate the arranty.
M OUNTING THE P ORT T O A H OUSING
Detach A from the port by turning it anti-clock ise hile holding B firmly.
Install the camera body only into the housing.
*Please refer to the housing manual for installing camera into the housing.
Align the port mounting indices of B and the housing. Gently push B into the
port opening of the housing, until it cannot go in any further.
*Please refer to housing manual for locking and un-locking the port.
Make sure the zoom knob is at its most out ards position before mounting/
un-mounting the lens. The knob should be left at this position until it is made
sure that the lens and zoom gear is properly installed.
A
B

Remove the O-ring from A, inspect for any damage and lightly coat it ith the
provided lubricant. Clean the O-ring groove before placing it back.
Verify that the threaded section of B and sealing surface are clean and free
from foreign material.
Align the external threaded section of A and the internal threaded section of
B.
Attach A on B by holding the housing firmly and turning A clock ise until it
cannot go in any further.
Engage the gear by pushing the knob in ards, then turn the knob both ays
to check if the lens zoom in and out.
To un-mount the port, reverse the above steps.
A
B