Nauticam M67 User manual

Current as of 2019-03-18
Instruction Manual for
M67 Double Flip Holder
for M67 Macro Ports
PN# 25108
FOREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the
requirements of professional as well as amateur underwater
photographers and fulfill them through the innovative designs of our
products. We strive to achieve a high level of user-friendliness by
allowing stress-free installation and easy operation of all important
functions of the camera.
Please read this manual carefully before using the product, this will
maximize its performance as well as its lifetime.
WARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for
consumer use. This warranty only applies to products purchased from
authorized NAUTICAM dealers and does not extend beyond the original
retail purchaser.
To return your product for service, please contact your regional
authorized service center(s). Please note that this warranty only applies
when the product is purchased in the territory where the service center
is located.
NAUTICAM does not hold responsibility for damage, of any nature, to
any equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthorized modifications and/or repairs of our products will
automatically invalidate the warranty.
INSTALL TO THE PORT
1. Press the lever and flip the holder to the side
2. Remove the locking ring from the flip holder
3. Align the two positioning screws on the back
of the holder with the slots on the front of
the port.
The position of the flip holder can be
changed by relocating the two screws in the
threaded holes around holder.

Current as of 2019-03-18
Soak the flip holder in fresh water after each dive and use
air blower to remove any sands or dusts in the hinge part.
*This M67 Double flip holder has been designed to use with
Naticam Wet Lenses, such as MWL, SMC and CMC, which means
that this holder has to support the weight of those lenses. Hence,
tightness of the hinge is necessary and normal.
Remark: All Nauticam product manual will be changed to e-manual in end of
2018. Please download corresponding product manuals on Nauticam.com
website, or contact us for e-manuals.
CARE AND MAINTENANCE
4. Fasten the holder by screwing the locking
ring into the thread on the front of the
port.
5. To un-mount the double flip holder from
the port, reverse the above steps.