Nautiraid RAID 325 User manual

RAID 325
Instruction Book

• Get your parts out of the bag : check how they are stored in the bag
and how the skin is plied. It will help you when you will get the
disassembled parts back in the bag after your paddling session.
• Display them on a flat and clean surface.
Your Narak Cross bag contents : 1- skin. 2- inflatable seat.
3- crossribs. 4- bow part. 5- aluminum tubes. 6- stern part.
Front crossribs (red marks).
Rear crossribs (blue marks)
crossrib n°1
crossrib n°2
crossrib n°4
crossrib n°3
1 2
3
4 5 6

• Start by assembling all the tubes.
• Find the keel tube (without ends).
• Align all the red marks on the other tubes.
• This way at the other end you identify two long tubes
(upper tubes) and two short ones (lower tubes).

• Take the bow part and slide it
into the keel tube (red marks)
• Clip all the crossribs to the
keel tube, following the color
code. All the marks has to be
below and on the same side
(see below).
• Do the same for the rear

• Go to the rear of the boat. Take the two longer tubes and connect
them to the top nipples, by sliding the blue caps.
(red caps go at the bow)
• Clip the upper tubes to the crossribs, all the way to the front end.
• Do the same for the rear

• put in place
the last remai-
ning short tubes
(deck tubes)
(red at the front,
blue at the rear).
• Connect the
bow part to
the top tubes.
• Now you can
connect the
lower tubes and
clip them all the
way to the rear
end.

• Clip them at the top of the central crossribs.
• Your frame is assembled.

FOOTREST INSTALLATION
When assembling for the first time your kayak, you have to adjust the
footrest, connected to the seat.
The footrest will be clipped on
the keel tube.
Put it in place between crossrib n°1 and
2.
Inflate the seat and put it in the kayak. Tie the seat straps at the rear around
the crossrib.

Do the same at the front with the
narrow straps.
Seat into the kayak and adjust the straps to the legth of your legs.
Connect the footrest to the seat with
the large straps.

• Get the frame into the skin.
• Be careful that the frame has to be
perfectly centered in the skin : the top
tube has to be aligned with the black
triangle on deck.
• Push the frame in the skin to the max.
ASSEMBLY FOLLOWING