NAVAC NEF6LM User manual

SAVE THIS MANUAL
FOR FUTURE REFERENCE
NEF6LM
NAVACInc.
www.NavacGlobal.com
User Manual
Cordless Power Flaring Tool
MADE IN CHINA
Tel/Fax: +1 877 MY-NAVAC
8 77 696 2822

Safety Guide
Contents
Structure and Technical Parameters
Operation Instruction
Troubleshooting
Exploded View and Parts List
01
03
05
06
Structure
Technical Parameters
Start button
Clamp
Lever
Battery
Light
Hold 2s to Reset
Battery balance indicator
Flaring indicator
Light
NEF6LM
Tubing Type
Tubing OD
Power
Cone Speed
Battery Capacity
Time to Flare
1/4", 3/8", 1/2", 5/8",3/4"
DC motor
Copper
120 RPM
Up to 100 flares per charge
Complete a flare in < 30 seconds
QuickCharge 30minutes
Dimension 10"x4"x4" (265x101x100mm)
Battery pack
Battery 7.4V 2Ah 14.8Wh
Power Supply
Output Voltage
Output Current
AC 100-240V (50/60Hz ) 50W
8.4V
3.5A
Ambient Temperature 41°F-104°F (5°C-40°C)
Charger
Ambient Temperature
01
Caution: Read this manual thoroughly before using.
............................................................
ŸKeep the working area clean and tidy.
ŸDo not operate while under the influence of alcohol.
ŸKeep children and untrained people from using.
ŸUse original parts and auxiliary.
ŸLong time using may overheat its motor which activate overheat protection.
ŸTemperature higher than 158°F (70°C) or lower than 4 1 °F (5°C)may activate the motor
overheat or subcooled protection.
ŸDon’t dismantle NEF6LM at random which may void warranty.
ŸProduct is warranted against defects in materials and workmanship for two years from the
date of purchase.
ŸDispose the battery according to local regulations.
ŸPending patent.
Model
..... ........ ........ ............... ........ ....
Table 1
Weight 2.9 lbs (1.3kg)
41°F-104°F (5°C-40°C)
............................................................................

Operation Instruction
0302
2. Get the clamp placed.
ŸKeep the lever open and put in the clamp. A locked lever resists the clamp being placed.
ŸPush the lever inward to lock the clamp.
3. Press the START button to flare.
Copper
Limit baffle
Clamplegs
Figure 1
Figure 2
Clamp
Lever
Locking the clamp
Figure 3
Caution:
Make sure hash marks lineup. Otherwise
it may cause a defective flare and
damage the clamp.
Caution:
ŸDon’t open the lever during flaring, otherwise the automatic flaring stops.
ŸIf it happens, press the reset button 2 seconds to draw back the cone.
ŸMake sure the clamp is still horizontally placed.
ŸPress inward the lever to lock the clamp again.
ŸPress the start button to reflare.
Light
Flaring
Hold 2s to R eset

0504
Troubleshooting
Problem Possible cause Solution
Adjusting bolt
(5mm Hex)
Locking nut
(1.5mmHex)
30°
Charger indicator flashes hurriedly.
Short circuit.
Battery ID not recognized.
Overheat or subcooled of the
battery pack.
Contact NAVAC TechSupport.
Cool down or warm up the
battery pack.
Use an original battery.
Flaring indicator flashes once
cyclically.
Flaring indicator flashes twice
cyclically.
Flaring indicator flashes three times
cyclically.
Figure 7
It does not flare or it stops during
flaring.
Low battery balance.
Motor or circuit board failure.
Lever’s locking is loose.
Copper does not touch the
baffle.
The copper flare is too small.
Tighten the lever. (Figure 7)
Make them contact.
Copper not deburred. Debur the copper.
Battery Charge
2. Make sure the battery pack is connected properly.
Charging
Bulge
Figure 4
Figure 5
Slot
Figure 6
Table 2
Flaring indicator flashes four times
cyclically.
Overload. Or the cone cannot
be reset.
Battery damaged. Try another battery.
Charge the battery.
Dirty on the batter
connections. Clean the connections.
Contact NAVAC TechSupport.
Contact NAVAC TechSupport.
Caution:
ŸTo tighten the lock, loose the locking nut first.
ŸThen turn the bolt clockwise 30 degree each time to check
the tightness.
ŸDon’t turn clockwise too much each time because it may
over-tight the lever and cause damage.
1. Charge battery when the last indicator flashes which means low battery.
3. Place back the battery pack.
Charging:
Full:
Fault: Flash hurriedly
Flash calmly
Indicator keeps on
Inp ut: AC 10 0~240 V 50-60 Hz 50W
Out put: DC 8 .4V 3.5 A
Charger

Part No. Item
Ref No.
Spare Parts List
Figure 8
Exploded View
Table 3
0706
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
PNEF1
PNEF2
PNEF3
PNEF4
PNEF5
PNEF6
PNEF7
PNEF8
PNEF9
PNEF10
PNEF11
PNEF12
PNEF13
PNEF14
PNEF15
PNEF16
PNEF17
PNEF18
PNEF19
PNEF20
PNEF21
PNEF22
PNEF23
PNEF24
PNEF25
PNEF26
PNEF27
PNEF28
PNEF29
PNEF30
PNEF31
PNEF32
PNEF33
PNEF34
PNEF35
PNEF36
PNEF37
PNEF38
PNEF39
PNEF40