NCR 7409-K312 Manual

7409-K312
Fixed Angle Mount Image
Scanner
Kit Instructions
Issue A

Revision Record
Issue Date Remarks
A July 2011 First issue

1
Introduction
This kit provides an Imaging Scanner for the following terminals.
NCR RealPOS 25 (7610)
NCR RealPOS 50 (7611)
The assembly installs on the front of the 7409-K035 Fixed Angle Mount.
2
98
1
3
MS 4980 Imaging Scanner
006-8615166
MS4980 Imaging Scanner Cable
497-0472847
Screw, 6-32 x 1/4, Phillips, PH
006-8611016
Filler Plate
497-0471591
Scanner Bracket
795-0164700

2
Installation Procedures
1. Remove the screws (2) in the sides of the Fixed Angle Mount.
Hex Screw
(One Each Side)
2. Rest the bottom of the display on the Display Support.
Display Support

3
3. Remove the Blank Faceplate from the Fixed Angle Mount (2 screws).
Blank Faceplate
4. Hook the bottom of the Fixed Angle Mount Faceplate and Image Scanner Assembly onto
the bottom edge of the opening on the front of the Fixed Angle Mount and secure it with
screws (2).
FixedAngle Mount Faceplate

4
5. Remove the Cable Cover from the terminal and connect the cables to the terminal
I/O Panel.
a. Connect the scanner serial cable to an RS-232 Connector.
Warning: The Imaging Scanner is a 5 Vdc device. Make sure the serial port
is set to 5 V. See following pages for port settings.
b. Connect the scanner USB cable to a USB Connector.
USBAUSB B RS232/CRS232/A RS232/B

5
7610 Serial Port Jumper Settings
28687a
* Default setting
COMD
COMC
COMA
COMB
Ring Indicator
12 V
5 V
* Default settin
g
Ring Indicator
12 V
5 V

6
7611 Serial Port Jumper Settings
28764
COMCCOMBCOMA
COMD
* Default settin
g
Ring Indicator
12 V
5 V
* Default setting
Ring Indicator
12 V
5 V

7
6. Close the Cable Cover.
7. Close the Display onto the Fixed Angle Mount and secure it with screws (2).
Hex Screw
(One Each Side)