NEC GT5000 Series User manual

Wireless LAN
Quick Setup Guide
for the following models:
LT220/240/240K/260/260K
MT860/1060/1060R/1065
GT5000/6000/6000R v2.0
oProjector Setup
oWindows Setup
oUsing NEC Software
NEC Solutions (America), Inc.
Visual Systems

Only the following Wireless LAN cards will work in the projector:
•Samsung MagicLAN (5volt version only)
•Linksys WPC11
•ZCOM LANEscape XI-300
1. Open the projector’s LAN menu and click on
manual IP setting and use the IP address
192.168.010.011
2. Use the subnet Mask 255.255.255.0
(Note: The last three digits can be assigned to many
different LAN components. However, each
component can have only one unique address to
avoid conflict.)
Click on OK and the projector is ready for use.
3- Next, select Network type and click on
Adhoc, or Adhoc 802.11
(Note: Infrastructure mode is to be used only
when connecting to an existing network
via an access point.)
Projector Setup

Windows Setup
There are a variety of Wireless LAN cards available. We recommend that you select a WiFi compliant card
for your PC.
2- Use the CD-Rom supplied
by the manufacturer to
install the drivers need for
Windows.
3- After detection is complete, find and
open Wireless Network Properties.
4- Under General tab, click on configure
and then Advanced tab. Change the
operating mode for your card to
AdHoc, or 802.11 AdHoc.
Click on OK
1. Insert you selected Wireless LAN card into
the PCMCIA slot of your laptop and wait for
the new found hardware wizard to appear.
Do not install any utilities included with
your LAN card. It is best if Windows is
allowed to control the wireless LAN card.

Continued
1- Next, Click on TCP/IP and
then Properties.
(Note: There may be several
TCP/IP configurations.
Make sure you click on the
one related to the Wireless
LAN card.)
2- Click to change the IP
address manually and input the
IP and subnet mask settings as
shown.

Using NEC Software
1. Start NEC Dynamic Image
Utilities.
2- Click on Options, then
Communication settings.
A window will appear where you will
select Autosearch LAN.
The software will search and detect
any projectors that are connected to
LAN or are in range or Wireless
connectivity.

Continued
Once the connection is made, select Tools,
then Image Express Utility Start.
A list will appear with all the projectors that
are present and available. Put a checkmark in
the box before a projector and click on
connect.
Once connected to a projector, an icon
will appear in the Systems Tray
resembling a projector. You can switch
to single frame transmit in order to allow
other users send single frame at a time.

Continued
Finally, you can go into projector control
mode by clicking on Mode, then PJ
Manager.
A menu will appear with all the available projectors
and their status. You can control any and all
projectors on the list.