2NEC Versa LitePad Tablet PC 512-MB Memory Module
Removing the memory module
A–Locking Tabs B–Memory Module
4. Install the new memory module as follows.
Locate the alignment notch on the module. Align the notch with the key in the slot
connector.
Holding the memory module at a 40-degree angle to the socket, insert the module
connector into the socket. Firmly push the module into the socket.
Press down on the edge of the memory module until the locking tabs on the sides of
the socket snap into place, securing the module.
Installing the memory module
A–Module Alignment Notch
5. Replace the memory bay cover and its screw.
6. Turn the system over. Reinstall the battery pack and reconnect the peripherals and the
AC adapter power cable.
Information in this publication is subject to change without notice. Versa LitePad is a trademark of NEC Solutions (America), Inc.
NEC and Empowered by Innovation are either registered trademarks or trademarks of NEC Corporation. All other trademarks
and registered trademarks are the property of their respective owners. Copyright ©2003 NEC Solutions (America), Inc.
All Rights Reserved.
*819-201011-000*
819-201011-000
2/2003
NEC Solutions (America), Inc.
Mobile Solutions Division
www.necsolutions-am.com/mobilesolutions