NETGEAR FVG318 - ProSafe 802.11g Wireless VPN Firewall 8... Specification sheet

Introduction 2-1
v1.0, October 2005
Chapter 2
Introduction
This chapter describes the features of the NETGEAR ProSafe Wireless 802.11g VPN Firewall
Model FVG318.
Key Features of the Wireless VPN Firewall
The ProSafe Wireless 802.11g VPN Firewall Model FVG318 with eight-port switch connects your
local area network (LAN) to the Internet through an external access device such as a cable modem
or DSL modem and provides 802.11b/g wireless LAN connectivity.
The FVG318 is a complete security solution that protects your network from attacks and
intrusions. Unlike simple Internet sharing firewalls that rely on Network Address Translation
(NAT) for security, the FVG318 uses stateful packet inspection for Denial of Service attack (DoS)
protection and intrusion detection. The FVG318 allows Internet access for up to 253 users. The
FVG318 wireless VPN firewall provides you with multiple Web content filtering options, plus
browsing activity reporting and instant alerts — both via e-mail. Parents and network
administrators can establish restricted access policies based on time-of-day, Web site addresses
and address keywords, and share high-speed cable/DSL Internet access for up to 253 personal
computers. In addition to NAT, the built-in firewall protects you from hackers.
With minimum setup, you can install and use the firewall within minutes.
The FVG318 wireless VPN firewall provides the following features:
• 802.11g and 802.11b standards-based wireless networking.
• Wireless Multimedia (WMM) support.
• Easy, Web-based setup for installation and management.
• Front panel LEDs for easy monitoring of status and activity.
• Content filtering and site blocking security.
• Built-in eight-port 10/100 Mbps switch.
• Ethernet connection to a WAN device, such as a cable modem or DSL modem.
• Extensive protocol support.
• Flash memory for firmware upgrade.

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
2-2 Introduction
v1.0, October 2005
802.11g and 802.11b Wireless Networking
The FVG318 wireless VPN firewall includes an 802.11g-compliant wireless access point. The
access point provides:
• 802.11b standards-based wireless networking at up to 11 Mbps.
• 802.11g wireless networking at up to 54 Mbps, which conforms to the 802.11g standard.
• WPA and WPA2 enterprise class strong security with RADIUS and certificate authentication
as well as dynamic encryption key generation.
• WPA-PSK and WPA2-PSK pre-shared key authentication without the overhead of RADIUS
servers but with all of the strong security of WPA and WPA2.
• 64-bit and 128-bit WEP encryption security.
• WEP keys can be generated manually or by passphrase.
• Wireless access can be restricted by MAC Address.
• Wireless network name broadcast can be turned off so that only devices that have the network
name (SSID) can connect.
Wireless Multimedia (WMM) Support
WMM is a subset of the 802.11e standard. WMM allows wireless traffic to have a range of
priorities, depending on the kind of data. Time-dependent information such as video or audio will
have a higher priority than normal traffic. For WMM to function correctly, wireless clients must
also support WMM.
A Powerful, True Firewall with Content Filtering
Unlike simple Internet sharing NAT firewalls, the FVG318 is a true firewall, using stateful packet
inspection to defend against hacker attacks. Its firewall features include:
• DoS protection.
Automatically detects and thwarts DoS attacks such as Ping of Death, SYN Flood, LAND
Attack, and IP Spoofing.
• Blocks unwanted traffic from the Internet to your LAN.
• Blocks access from your LAN to Internet locations or services that you specify as off-limits.
• Logs security incidents.

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Introduction 2-3
v1.0, October 2005
The FVG318 logs security events such as blocked incoming traffic, port scans, attacks, and
administrator logins. You can configure the firewall to email the log to you at specified
intervals. You can also configure the firewall to send immediate alert messages to your e-mail
address or email pager whenever a significant event occurs.
• With its content filtering feature, the FVG318 prevents objectionable content from reaching
your PCs. The firewall allows you to control access to Internet content by screening for
keywords within Web addresses. You can configure the firewall to log and report attempts to
access objectionable Internet sites.
Security
The FVG318 wireless VPN firewall is equipped with several features designed to maintain
security, as described in this section.
• PCs Hidden by NAT
NAT opens a temporary path to the Internet for requests originating from the local network.
Requests originating from outside the LAN are discarded, preventing users outside the LAN
from finding and directly accessing the PCs on the LAN.
• Port Forwarding with NAT
Although NAT prevents Internet locations from directly accessing the PCs on the LAN, the
firewall allows you to direct incoming traffic to specific PCs based on the service port number
of the incoming request, or to one designated “DNS” host computer. You can specify
forwarding of single ports or ranges of ports.
Autosensing Ethernet Connections with Auto Uplink
With its internal eight-port 10/100 switch, the FVG318 can connect to either a 10 Mbps standard
Ethernet network or a 100 Mbps Fast Ethernet network. Both the LAN and WAN interfaces are
autosensing and capable of full-duplex or half-duplex operation.
The firewall incorporates Auto UplinkTM technology. Each Ethernet port automatically senses
whether the Ethernet cable plugged into the port should have a normal connection such as to a PC
or an uplink connection such as to a switch or hub. That port then configures itself to the correct
configuration. This feature also eliminates the need to worry about crossover cables, as Auto
Uplink will accommodate either type of cable to make the right connection.
Extensive Protocol Support
The FVG318 wireless VPN firewall supports the Transmission Control Protocol/Internet Protocol
(TCP/IP) and Routing Information Protocol (RIP). For further information about TCP/IP, refer to
“Internet Networking and TCP/IP Addressing:” in Appendix A.”

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
2-4 Introduction
v1.0, October 2005
• IP Address Sharing by NAT
The FVG318 wireless VPN firewall allows several networked PCs to share an Internet
account using only a single IP address, which may be statically or dynamically assigned by
your Internet service provider (ISP). This technique, known as NAT, allows the use of an
inexpensive single-user ISP account.
• Automatic Configuration of Attached PCs by DHCP
The FVG318 wireless VPN firewall dynamically assigns network configuration information,
including IP, gateway, and Domain Name Server (DNS) addresses, to attached PCs on the
LAN using the Dynamic Host Configuration Protocol (DHCP). This feature greatly simplifies
configuration of PCs on your local network.
• DNS Proxy
When DHCP is enabled and no DNS addresses are specified, the firewall provides its own
address as a DNS server to the attached PCs. The firewall obtains actual DNS addresses from
the ISP during connection setup and forwards DNS requests from the LAN.
• Point-to-Point Protocol over Ethernet (PPPoE)
PPPoE is a protocol for connecting remote hosts to the Internet over a DSL connection by
simulating a dial-up connection. This feature eliminates the need to run a login program such
as Entersys or WinPOET on your PC.
Easy Installation and Management
You can install, configure, and operate the ProSafe Wireless 802.11g VPN Firewall Model
FVG318 within minutes after connecting it to the network. The following features simplify
installation and management tasks:
• Browser-based management
Browser-based configuration allows you to easily configure your firewall from almost any
type of personal computer, such as Windows, Macintosh, or Linux. A user-friendly Setup
Wizard is provided, and online help documentation is built into the browser-based Web
Management Interface.
• Smart Wizard
The FVG318 wireless VPN firewall automatically senses the type of Internet connection,
asking you only for the information required for your type of ISP account.
• Diagnostic functions
The firewall incorporates built-in diagnostic functions such as Ping, DNS lookup, and remote
reboot.

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Introduction 2-5
v1.0, October 2005
• Remote management
The firewall allows you to login to the Web Management Interface from a remote location on
the Internet. For security, you can limit remote management access to a specified remote IP
address or range of addresses, and you can choose a nonstandard port number.
• Visual monitoring
The FVG318 wireless VPN firewall’s front panel LEDs provide an easy way to monitor its
status and activity.
Maintenance and Support
NETGEAR offers the following features to help you maximize your use of the FVG318 wireless
VPN firewall:
• Flash memory for firmware upgrade.
• Free technical support seven days a week, 24 hours a day.
Package Contents
The product package should contain the following items:
• ProSafe Wireless 802.11g VPN Firewall Model FVG318.
•ACpoweradapter.
• Category 5 (Cat 5) Ethernet cable.
• Installation Guide.
•Resource CD, including:
— This guide.
— Application Notes and other helpful information.
• Registration and Warranty Card.
If any of the parts are incorrect, missing, or damaged, contact your NETGEAR dealer. Keep the
carton, including the original packing materials, in case you need to return the firewall for repair.

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
2-6 Introduction
v1.0, October 2005
The FVG318 Front Panel
The front panel of the FVG318 wireless VPN firewall contains the status LEDs described below.
You can use some of the LEDs to verify connections. Viewed from left to right, Table 2-1
describes the LEDs on the front panel of the firewall. These LEDs are green when lit.
Figure 2-1

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Introduction 2-7
v1.0, October 2005
Table 2-1. LED Descriptions
LED Label Activity Description
PWR On Power is supplied to the firewall.
TEST On
Off The system is initializing. The system is ready and running.
INTERNET
100 (100 Mbps) On
Off The Internet (WAN) port is operating at 100 Mbps. The Internet (WAN) port is operating at 10 Mbps.
LINK/ACT
(Link/Activity) On Blinking The Internet port has detected a link with an attached device. Data is being transmitted or received by the Internet port.
LOCAL
100 (100 Mbps) On
Off The Local port is operating at 100 Mbps. The Local port is operating at 10 Mbps.
LINK/ACT
(Link/Activity) On Blinking The Local port has detected a link with an attached device. Data is being transmitted or received by the Local port.
WLAN On/Blink
Off The wireless interface is on/data transmission in progress. The wireless interface is off.

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
2-8 Introduction
v1.0, October 2005
The FVG318 Rear Panel
The rear panel of the FVG318 wireless VPN firewall contains the port connections listed below.
Viewed from left to right, the rear panel contains the following features:
• Detachable wireless antenna
• Factory default reset push button
• Eight Ethernet LAN ports
• Internet Ethernet WAN port for connecting the firewall to a cable or DSL modem
• DC power input
Figure 2-2
Antenna PowerINTERNET
Port
LOCAL
Ports
FACTORY
Reset Button

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Introduction 2-9
v1.0, October 2005
NETGEAR-Related Products
NETGEAR products related to the FVG318 are listed in the following table:
NETGEAR Product Registration, Support, and
Documentation
Register your product at http://www.NETGEAR.com/register. Registration is required before you
can use our telephone support service.
Product updates and Web support are always available by going to: http://kbserver.netgear.com.
Documentation is available on the Resource CD and at http://kbserver.netgear.com.
When the wireless VPN firewall is connected to the Internet, click the Knowledge Base or the
Documentation link under the Web Support menu to view support information or the
documentation for the wireless VPN firewall.
Table 2-1. NETGEAR-Related Products
Category Wireless Wired
Notebooks WAG511 108 Mbps Dual Band PC Card
WG511T 108 Mbps PC Card
WG511 54 Mbps PC Card
WG111 54 Mbps USB 2.0 Adapter
MA521 802.11b PC Card
MA111 802.11b USB Adapter
FA511 CardBus Adapter
FA120 USB 2.0 Adapter
Desktops WAG311 108 Mbps Dual Band PCI Adapter
WG311T 108 Mbps PCI Adapter
WG311 54 Mbps PCI Adapter
WG111 54 Mbps USB 2.0 Adapter
MA111 802.11b USB Adapter
FA311 PCI Adapter
FA120 USB 2.0 Adapter
PDAs MA701 802.11b Compact Flash Card
Antennas and
Accessories ANT24O5 5 dBi Antenna ANT2409 Indoor/Outdoor 9 dBi Antenna
ANT24D18 Indoor/Outdoor 18 dBi Antenna
Antenna Cables–1.5, 3, 5, 10, and 30 m lengths
VPN01L and VPN05L ProSafe VPN Client Software

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
2-10 Introduction
v1.0, October 2005