NETGEAR Orbi RBR350 User manual

Welcome to your new
Orbi Wi-Fi 6 router
What’s in the box?
1x NETGEAR Orbi Wi-Fi 6 router 1x Power adapter 1x Ethernet cable
1
Download the
Orbi app
2
Connect your
Orbi router
1. Connect the Ethernet cable to your Orbi’s Internet port, then connect
the other end to the port labelled LAN1 or GE1 on your Optical Network
Terminal – that’s the fibre box usually found on your wall.
2. Connect the power adapter and turn your Orbi on at the wall.
Got extra Orbi satellites? Find a place to plug them in now, or you can set
them up later. Orbi satellites must be within range of your Orbi router’s Wi-Fi
signal, so don’t place them too far apart from each other.
If you have a landline, connect it to the port labelled POTS or TEL on your
Optical Network Terminal.
LAN TEL
ONT

3
Connect to your
Orbi Wi-Fi network
1. Go to the Wi-Fi settings on your mobile device.
2. Connect to your Orbi Wi-Fi network. You’ll find the Wi-Fi network name
and password printed on the front of your Orbi router.
It may take a few minutes for your network to appear after
plugging in your Orbi.
4
Open the Orbi app
and follow the
setup instructions
Important: Skip the steps instructing you to disconnect and reconnect your
ISP modem. These steps don’t apply – just select ‘Continue’.
That’s it, your Orbi router is up and running!
For NETGEAR’s Privacy Policy, visit www.netgear.com/about/privacy-policy.
By using this device, you are agreeing to NETGEAR’s Terms and Conditions at
www.netgear.com/about/terms-and-conditions. If you do not agree, contact
Slingshot at www.slingshot.co.nz/contact to return your device.