Neumann.Berlin TLM 107 User manual

Quick Guide
Kurzanleitung
Guide rapide
Guida rapida
Guía de inicio rápido
Guia rápido
Beknopte handleiding
Krótka instrukcja obsługi
Snabbguide
Kort vejledning
Pikaohje
Γρήγορος οδηγός
Kısa Kılavuz
Краткая инструкция
快速指南
クイックガ イド
퀵 가이드
 
   · .  ·   · 
  () /    - ·  - · @. · ..
. / · /
TLM 107
Studio Set
TLM 107 & SG 2
TLM 107 & EA 4
SG 2
EA 4
TLM 107
TLM 107
Instruction manual | Bedienungsanleitung | Notice d'emploi |
Istruzioni per l'uso | Instrucciones de manejo | Manual de
instruções | Gebruiksaanwijzing | Instrukcja obsługi |
Bruksanvisning | Betjeningsvejledning | Käyttöohje | Οδηγίες
λειτουργίας | Kullanım kılavuzu | Инструкция по эксплуатации |
使用说明书 | 取扱説明書 | 사용 설명서 |
www.neumann.com | TLM 107
For details on further optional accessories see www.neumann.com
XLR-3

Specifications
lin
40 Hz
100 Hz
0 dB
-6 dB
-12 dB
Change settings
LEDs on
High-pass filter
Pre-attenuation
Acoustic operating principle
Directional pattern
Frequency range
Sensitivity at 1 kHz into 1 kΩ
Rated impedance
Rated load impedance
Signal-to-noise ratio, CCIR
1)
(rel. 94 db SPL)
Signal-to-noise ratio, A-weighted
1)
(rel. 94 db SPL)
Equivalent noise level, CCIR
1)
Equivalent noise level, A-weighted
1)
Maximum SPL for THD ≤ 0.5%
2)
Maximum SPL for THD with pre-attenuation -6 dB
Maximum SPL for THD with pre-attenuation -12 dB
Max. output voltage for THD > 0.5%
Supply voltage (P48, IEC 61938)
Current consumption (P48, IEC 61938)
Matching connector
Weight
Dimensions (diameter / length)
Operating temperature range
Storage temperature range
Humidity range
Pressure gradient transducer
Omni, wide angle cardioid,
cardioid, hypercardioid, figure 8
20 Hz - 20 kHz
11 mV/Pa –39 dBV ± 1 dB
50 Ω
1000 Ω
72 dB
84 dB
22 dB
10 dB-A
141 dB
147 dB
153 dB
10 dBu
48 V ± 4 V
3.2 mA
XLR3F
445 g
 64 mm / 145 mm
0 °C - +70 °C (32 °F - 158 °F)
−20 °C - +70 °C (−4 °F - 158 °F)
max. 90 % at +20 °C
1)
according to IEC 60268-1; CCIR-weighting according to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2)
measured as equivalent el. input signal