Neutral Posture 1000 Series User manual

1000 Series
Multi-function
1. Lumbar Height
3. Seat Angle
front lever
4. Back Angle
rear lever
2. Seat Height
middle lever
5. Seat Tilt Tension
6. Forward Tilt-stop
7. Seat Slider
8. Arm Width
9. Arm Height
11. Arm Pad Position
10. Arm Pad Rotation

T979.778.0502 •NeutralPosture.com
08/2012 © 2012 Neutral Posture, Inc. All rights reserved. Women Owned Small Business
1000 Series - Multi-function
1. Lumbar Height - Locate the support inside the
backrest and slide up or down. Position the support
to t comfortably in the curve of your lower back.
2. Seat Height - Lift the lever and lift your weight
to raise the seat to the desired position. To lower
the seat, lift the lever while remaining seated.
3. Seat Angle - Push down to adjust seat angle. Lift to lock
into place. For rocking, push the lever all the way down.
4. Back Angle - Lift lever and recline to your desired
position. Release lever to lock into place.
5. Seat Tilt Tension - From in front of the chair turn
the knob to the right to increase tension or turn
the knob to the left to decrease tension.
6. Forward Tilt-stop - To increase forward tilt, recline
seat angle slightly and then rotate the control
forward. To reduce, rotate the control backward.
7. Seat Slider (Depth) - With your back against the backrest,
lift the lever to disengage the lock and slide the seat to your
desired position. Release the lever to lock the seat in place.
8. Arm Width - Push lever down to release the
arm and slide the arm to the proper position.
Lift lever to lock arm into place.
9. Arm Height - Press button to adjust height
until your arms are properly supported.
10. Arm Pad Rotation - Squeeze the lever under the
front of the arm pad to rotate in a full 360° circle.
Release the lever to lock into desired position.
11. Arm Pad Position - Squeeze the button on the edge
of the pad to release and slide in any direction.