Neutral Posture Big & Tall Series User manual

Assembly
Neutral Posture Big & Tall Series
Time 10 minutes
People 1
Tools 3/16” Hex Wrench (provided)
Parts Flat head hex screws (4)
Instructions:
1. Remove unit from box.
2. Remove two 2-1/2” screws from each urethane cover. Set aside.
3. Remove urethane covers from arm. Set aside.
4. Remove two 1/2” hex screws from each arm bracket. Set aside.
5. Decide on T-bar and Pad FORWARD or REAR positioning.
a. By default, the vertical stitching on the inside of the armpad
should face the inside of the chair. As shipped, this places
the armpad FORWARD and to the INSIDE. If you would like
the armpads in the REAR position, simply rotate the T-bar and
Pad assembly around 180°. Now the vertical arm pad stitching
will be to the outside and your armpad is to the REAR and OUTSIDE.
6. Decide on armpad IN-OUT positioning.
a. The distance between the armpads can be adjusted. To do so,
unscrew the 2 screws beneath each armpad and move it in or
out to the desired position. Use the same 2 screws to reattach
armpad in new position.
NOTE: Urethane cover must be unscrewed then pulled down to access
the 2 screws which are used to move the armpads laterally.
7. Decide HEIGHT position
a. Decide how high you would like the armrest.
Chair Front
FROM ABOVE
24”
22”
FROM THE FRONT
Front
FROM THE SIDE
NeutralPosture • www.iGoErgo.com • 800.446.3746 (iGoErgo)
(over)
Rear
Forward
Out
In
May 04
Rev. 1
T-BAR & PAD
(Step 5a)
(Step 5a)
(Step 6)
(Step 7)

8. Bolt the T-bar and Pad assembly to the arm bar.
a. Slide the urethane cover down onto the metal arm bar.
IMPORTANT! Before doing this, decide which
way the urethane cover should be turned. This
will be based on your decision made in step 5.
b. Push the urethane cover down around the bend in the metal arm
bar. This will expose all 5 mounting holes.
c. Hold the T-bar and Pad assembly to the inside of the arm bar
and align mounting holes with corresponding holes at the desired height.
d. Insert Flathead hex screw (1/2” long, supplied) into upright from
the outside of bracket and thread into T-bar. Tighten with hex wrench.
e. Repeat process for second screw.
9. Install arm covers.
NeutralPosture • www.iGoErgo.com • 800.446.3746 (iGoErgo)
Assembly
If you have any questions about how to properly adjust your Big & Tall chair, visit our website at
www.iGoErgo.com or call our customer service department at (800) iGo-Ergo (446-3746). Let us know
if there is anything we can do to help you get the best possible use out of your Neutral Posture chair.
T-bar and Pad
Assembly
Cover is pushed down to
expose mounting holes
T-bar assembles to inside of
arm bar
5 mounting holes
a. Slide (pull up) urethane cover against the bottom of the pad.
b. Carefully insert one of the truss-head screws (2-1/2” long, supplied) into one of the holes
located on the back and front edge of the urethane arm cover and thread into the T-bar.
Hand tighten only! Repeat for the second hole in the arm cover.
c. Repeat steps 8 & 9 for the other arm.
May 04
Rev. 1
(Step 8a)
(Step 9b)