Neutral Posture Renati User manual

Renati™ Installation Guide
Hardware (Included) 1 – 5mm Allen wrench
6 – 35mm screws
2 – 20mm screws
People 1 Person
Time 10 - 15 minutes
Install Casters & Cylinder
Firmly press all casters into base.
Set cylinder into base.
1
Install Arms
Install six 35mm long screws to attach arms to seat.
Make sure other holes on bottom cover are not blocking
threads.
Mech Install
Install two 25mm screws on front of mechanism. Install
two 35mm screws on rear of mechanism.
Back Install
Install four 40mm screws to secure backrest.
Install Seat & Back Assembly
Place seat assembly upright and onto base assembly.
Install Headrest
Loosen headrest clamp screws. Then attach headrest
clamp around the back lip of the chair and tighten
screws. Ensure headrest is tight.
2
4
3
Replacement Instructions

Renati™ Adjustment Guide
T979.778.0502 F979.778.0408 •NeutralPosture.com
06/2016 © 2016 Neutral Posture, Inc. All rights reserved.
Lumbar
Adjust lumbar by simply sliding backpiece up and down.
Headrest
Headrest adjusts vertically and can swivel.
Tilt
Push lever arm inward to lock back tilt. Pull lever arm out
to allow backrest to freely tilt.
Tension
Rotate knob clockwise to tighten backrest tilt tension
and counter-clockwise to loosen tension.
Height
Pull upward on lever to adjust seat height.
Armrest
The arm pad can slide forward and backward. Depress
the button on the outside of the arm to adjust height.