NewBeeDrone AcroBee Lite User manual

• Carrying Case
• FPV Box Goggle
• AcroBee Container With Charger
• Radio
• AcroBee Lite
• 4 HV 4.35V 250mAh Nitro Nectar Batteries
• Micro USB Charging Cable
• 4 Spare Propellers
BOX CONTENTS:
• Take out the AcroBee from AcroBee Container.
• Plug in USB and charge goggle screen and radio.
• Charge Nitro Nectar batteries with charging port
from AcroBee Container.
• Power on radio.
• Insert battery into AcroBee and plug in battery
lead.
PRE-FLIGHT INSTRUCTIONS:
• Plug in micro USB power source to AcroBee Contain-
er to power charger.
• Insert Nitro Nectar batteries into charging port.
• Charger LED indicator lights are solid red when
charging & solid green when full.
• Always remove battery when indicator light is solid
green.
CHARGING ACROBEE BATTERIES:
• When Radio & Goggle Screen are plugged into USB
cable with Data Link, LED will be solid red while
charging and turn solid green when charging is
complete.
• When Radio & Goggle Screen are plugged into USB
cable with power only, LED will be solid red while
charging, and turn off when charging is complete.
• Always remove charging cable when charging is
complete.
CHARGING GOGGLE & RADIO:
Turning On
Press the power button quickly two times. The radio
will play a start-up tone. The power button will light
up in yellow and the LED light below the power button
will display a solid green color.
Turning Off
Hold the power button for two seconds which will play
a power down tone and turn off all LED lights.
Binding Mode
Hold down the right trim button while powering up
the radio. The indicator green LED light will blink for
10 seconds while in bind mode until automatically
going back to normal mode and turning the LED solid
green again.
Flight Simulator
While the radio is powered on, hold down the right
trim button for 2 seconds and release. The LED will
turn solid blue indicating it is in flight simulator
mode. Radio must be connected to a computer via
micro USB cable to use.
RADIO FUNCTIONS:
Channel Button
Push down once to scroll through different channel
numbers.
Frequency Button
Push down once to scroll through different frequency
bands.
Menu Button
Push down once to scroll through options of adjusting
the screen (Brightness, Contrast, Color, Zoom, Reset).
GOGGLE SCREEN FUNCTIONS:
1
2
3
4
5
6
AcroBee Lite RTF Kit

NOTE: Your RTF Kit radio already comes prebound to
the AcroBee.
If you need to re-bind please follow the steps below:
• Plug in a Nitro Nectar battery to your AcroBee. After
you see the receiver LED turn on and blinking slowly
in red, press the bind button for one second which
will make the receiver LED on the board blink rapidly.
BINDING RADIO & ACROBEE: 7
• Put radio into bind mode by holding down the right
trim button while powering up the radio. The
indicator LED will blink green for 10 seconds while in
bind mode. After 10 seconds, it will automatically go
back to normal mode and the LED will return to solid
green.
• Once the AcroBee is bound to the radio, the LED will
slowly blink red and then turn solid red indicating
the bind is complete.
• Always keep a safe distance in all directions around
your model to avoid collisions or injury.
• Always operate your model in open spaces away from
full-size vehicles, traffic and people.
• Always carefully follow the directions and warnings
for this and any optional support equipment (charg-
ers, rechargeable battery packs, etc.).
• Always keep all chemicals, small parts and anything
electrical out of the reach of children.
• Always avoid water exposure to all equipment not
specifically designed and protected for this purpose.
• Never place any portion of the model in your mouth
as it could cause serious injury.
• Never operate your model with low transmitter
batteries.
• Always keep aircraft in sight and under control.
• Always move the throttle fully down at rotor strike.
• Always use fully charged batteries.
• Always keep transmitter powered on while aircraft is
powered.
• Always remove batteries before disassembly.
• Never operate aircraft with damaged wiring.
• Always keep parts dry.
• Never touch moving parts.
WARNINGS & SAFETY:
• NEVER LEAVE CHARGING BATTERIES UNATTENDED.
• NEVER CHARGE BATTERIES OVERNIGHT.
•Never charge damaged batteries. If the battery
begins to swell during charging or use, discontinue
immediately.
• Always use the included battery and charger. Discon-
nect the battery after charging.
• Charge batteries away from flammable materials in a
well-ventilated area.
• Never charge, transport, or store batteries in hot,
cold, or very sunny places.
CHARGING WARNINGS: