Next 145779 User manual

Tools Needed
Helpline
If you have any problems with this product or
require any replacement fittings please contact
Customer Services Tel: [phone]
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found to
be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
•Made in China
•Keep fittings out of children's reach and keep children well away from the construction area.
GLASS INFORMATION
•This item contains
g
lass. Please handle with extreme care.
•An
y
s
p
ills should be removed immediatel
y
with a soft clean damp cloth and dried immediately.
•We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
•Carefully check that you have all parts before beginning assembly.
•This product contains 8mm glass that does not conform to BS 6206. If the glass is chipped or broken replace with glass
of the type described.
•If the glass is chipped or broken, stop using the product and consult the manufacturer or supplier.
•Glass table top and MDF with black paint.
•We recommend that the packaging is used to protect the surfaces during assembly.
•A minimum of 2 persons is required to assemble this product.
•For general cleaning, periodically dust with a soft cloth.
•Do not rub or scrub the surface when cleaning.
CARE INSTRUCTIONS
PRODUCT INFORMATION
•Do not use this item if any structual part is broken or missing.
•Do not strike the glass with hard or pointed items.
•Clean using a glass cleaner and soft cloth. Do not use cleaning products containing abrasives as these will scratch .
•Never drag pieces of furniture across the floor as this will cause damage to the joints.
•All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
•Do not place very hot or cold items against or in close proximity to the glass surface unless adequately thick insulation
material is used to prevent such item from coming into contact with the glass.
Page 1 of 6
•Please remove plastic protection film on glass table top before use.
145779 SMOKED GLASS HIDEAWAY SET
• Ensure the products is protected with mats and coasters when item are placed on the surfaces. to prevent scratching.
• Do not put hot dishes directly on the surfaces of the item.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
IMPORTANT

Page 2 of 6
FITTINGS
Ax2
(M6x46mm) (M8x49mm) ( 12.5)
( 12x30mm)
( 17)
(M8x75mm) ( 12.5) (M8)
( 12x60mm) (M13.6) (M4) (M5)
Bx4 Cx8 Dx2 Ex12 Fx4 Gx8
Hx8 Ix4 Jx24 Kx1 Lx1 Mx1
PARTS
1
456
2 3
Table top x 1 Table leg x 4 Bottom bar x 1
Bottom Bar x 1 Top bar x 1 Top bar x 1
Ø Ø Ø
Ø Ø

STEP TWO
STEP ONE
1. Insert 2 x bolts (C) and 6 x wood dowels (J) to
table legs (2).
2. Repeat step 1 for another 3 x table legs (2).
1. Attach Bottom bar (4) & Top bar (6) to one of the
table leg (2) with 2 x half moon fittings (H), 2 x washers (E) &
2 x nuts (G) and tighten by using spanner (K).
Page 3 of 6

STEP FOUR
STEP THREE
1. Attach another table leg (2) to the assembled unit with 2 x half moon
fittings (H), 2 x washers (E) & 2 x nuts (G) and tighten
by using spanner (K).
1. Insert 4 x wooden dowels (I)
into the assembled unit.
2. Attach Bottom bar (3) & Top Bar (5)
to the assembled unit.
Page 4 of 6

STEP SIX
STEP FIVE
1. Attach 2 x table legs (2) to the assembled unit
with 4 x half moon fittings (H), 4 x washers (E)
& 4 x nuts (G) and tighten
by using spanner (K).
1. Fasten the cross bars with 2 x bolts (A) & 2 x washers (D)
and tighten by using allen key (L).
Page 5 of 6

STEP SEVEN
1. Pick out the glass table top (1) from the packaging box and place
it upside down onto the foam.
Please place the foam under the
table top for protection purpose.
2. Attach the assembled unit to the glass table top (1) with
4 washers (E), 4 x spring washers (F) & 4 x bolts (B) and
tighten by using allen key (M).
STEP EIGHT
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
Page 6 of 6
1. Upside down the table to correct position and remove
the plastic protection film on top.
N.B.: